Officezone KT7105-A Operation Manual

OfficeZone

www.officezone.com

1-800-543-5454

Ketec, Inc

Shoplifting Protection

VECTOR
KT7105-A

06502

OfficeZone

www.officezone.com

1-800-543-5454

Parts List …………………………….1
Assembly Instructions……………… 2
Positioning the System ……………. 3
Tagging Guidelines …………………4
Removing Hard Tag……………….. 7
Detection Area ……………………... 9
Alarm Handling …………………….. 10
Troubleshooting ……………………. 11
Warranty…………………………….. Back Cover

VECTOR USERS GUIDE

INDEX

www.officezone.com

1-800-543-5454

OfficeZone

Remove all contents from packaging. Compare products with the example. If you
are missing any parts please contact your supplier immediately. The carton should
contain:

VECTOR ANTENNA WITH WIRE BASEPLATE

PARTS LIST

CAP NUTS AND WASHERS

POWER SUPPLY WITH 10’ OF

CORD

5’ RUBBER MOLDING &

DOUBLE SIDED TAPE

1

www.officezone.com

1-800-543-5454

OfficeZone

1. Locate the baseplate, cap nuts
and washers.

2. Place the antenna on top of
the baseplate, aligning the
holes in the antenna base with
the studs on the baseplate.
Make sure that the power
supply wire is in the channels
of the antenna base and is not
crushed between the antenna
base and the baseplate.

3. Attach the washers and cap
nuts to the bolts on the
baseplate. DO NOT TIGHTEN.

4. Again make sure that the
power wire is not crushed
between the antenna base and
baseplate and tighten the cap
nuts with a ½” wrench.

5. Connect the wire on the power
supply to the power wire
connected to the antenna. The
wires will only connect in one
direction.

ASSEMBLY INSTRUCTIONS

2