Odys DPF-Vario User Manual

Page 1

ODYS DPF-Vario

1/6

ODYS DPF-Vario

CONGRATULATIONS on your purchase of our 7’’LCD Digital Photo Frame. Please read carefully and follow all warnings and instructions in this Use r’s Manual and tho se marked on the product b efore first use. Failing to follow these warnings could result in personal injury or damage to the Digital Photo Frame. Also, remember to keep this User’s Manual in a convenient location for future reference.

Important: Save the original box and all packing material for future shipping needs. IMPORTANT PRODUCT SAFETY INSTRUCTIONS Proper Handling of the Digital Photo Frame

Always handle the Digi tal Photo Frame with care. Avoid to uchi ng t he L CD scre en as na tura l ski n oil s are often difficult to remove. Always position the Digital Photo Frame on a stable and level surface. Unstable surfaces can cause the Digital Photo Frame to topple and fall, resultin g in possible damage or injury.

Avoid exposing the Digital Photo Frame to direct sunlight or high temperatures, which can damage or shorten its useful life. Do not place the unit near heat sources such as radiators, heat registers, or other appliances that gene rate heat. Orient the Digit al Photo Frame away from direct sunlight to reduce glare.

Avoid exposing the Digital Photo Frame to rain, water, moisture or high humidity. Do not place it in a bathroom or kitchen near a sink or where it may come in contact with water.

Never place heavy or sharp objects on the LCD panel, frame, or power cord.

Overloading Outlets

Do not overload electric al pow er sources w hen usi ng th e Digit al Pict ure Fram e. Ove rload ing wal l out let s, or extension cords can result in overheating, fire, or electric shock. Use only grounded or polarized outlets.

Power Cord Protection

Minimize wear on the power supply cord. The power supply cord should be routed away from foot traffic and contact with other objects. Do not route the power cord under rugs or carpeting. The cord should never be severely be nt, pin ched, or twisted . Periodi cally inspe ct the pow er cord a nd each e nd of the cord for wear or damage. Periodically inspect the power cord and each end of the cord for wear or damage.

Ventilation

Slots and openings on the Digital Photo Frame are provided for ventilation purposes. To ensure reliable operation of the product and to protect it from overheating, these openings must not be blocked or covered. Keep the Digital Photo Frame a minimum of four (4) inches away from any wall to assure sufficient airflow and ventilation. Increased temperatures may cause fire or device failure.

To assure proper ventilation , do not block the openings b y placing the Digital Photo Frame on a bed, sofa, rug or other similar surf ace. Do not pla ce it in a bui lt-i n in sta llati on, such a s a bookca se o r enclo sed rack, unless proper ventilation is provided.

Page 2

ODYS DPF-Vario

Other Notices and Precautions Caution: Never remove th e pl asti c casing. There are no user servicea ble parts inside. The Digi t al Photo

Frame contains high voltage parts. You may be seriously injured if you touch them. Do not attempt repairs yourself. The warranty does not cover repairs or attempted repairs by anyone not

authorized by Authorize Dealer. Refer all servicing and repairs to qualified service personnel. If the Frame begins to emit smoke, an abnormal noise, or a strange odor, immediately turn it off and

unplug the power cord. Contact the Authorize Dealer Servi c e Center. If the Digital Photo Frame will not be used for an extended period of time, unplu g the power cord.

Cleaning the Digital Photo Frame

• MAKE SURE THE DIGITA L PHOTO FRAME IS TURNED OFF

• NEVER SPRAY OR POUR LIQUID DIRECTLY ONTO THE SCREEN OR PLASTIC CASING To Clean the Screen:

1. Wipe the screen with a clean, soft, lint- free cloth. This removes dust and other particles.

2. If it still is not clean, apply a small amount of non-ammonia, non-alcohol based glass cleaner on a clean, soft, lint-lint-free cloth to clean the scr ee n.

To Clean the Plastic Casing:

1. Use a soft, dry cloth.

2. If it still is not clean, apply a small amount of non-ammonia, non-alcohol based, and mild non-abrasive detergent on a clean, soft, lint-free cloth to clean the surface.

To Clean the Frame:

Use a soft, dry cloth.

Disclaimer

Your Authorize Dealer does not recommend the use of any ammonia or alcohol-based cleaners on the LCD screen or plastic casing. Some chemical cleaners have been reported to damage the screen and / or display case. Your Authorize Dealer will not be liable for damage resulting from the use of any ammonia or alcohol-based cleaners.

Tips regarding environmental protection

At the end of its operating life, this product may not be disposed of by way of your normal household waste. Instead it must be delivered to a collection point for recycling electrical and electronic equipment. The icon on the product, in the operating instructions or on the packaging, indicates this.

The materials used in manufacturing this product are recyclable, depending on their identifying markings. By recycling this equipment, by recycling its components, or through other procedures of re-using outdated equipment, you are making an important contribution to protection our environment. Please ask you local municipal administration for the location of the corresponding recycling point.

Page 3

ODYS DPF-Vario

3/6

IInnttrroodduuccttiioonn ttoo aappppeeaarraannccee

Taste

Function

For playing or pausing.

Skip to anterior photo.

Skip to next photo.

Rotate the pictur e

MODE

For switching over th e frame display type.

LCD Screen

Mounting Bracket Screw Hole

SD card slot

Power Interface (Note 1)

Bracket

NNoottee 11:: PPuullll ooffff tthhee ppoowweerr aaddaapptteerr,, tthhee mmaacchhiinnee wwi

illll bbee ttuurrnneedd ooffff ccoommpplleetteellyy ffoorr lloonngg;; iiff tthhee ddeevviicc

ee iiss oouutt

ooff uussee ffoorr lloonngg,, iitt iiss pprrooppoosseedd ttoo ppuullll ooffff tthhee ppoow

weerr aaddaapptteerr.. PPlleeaassee aatttteennttiioonn:: oonnccee tthhee ppoowweerr aaddaapptt

eerr iiss

ppuulllleedd ooffff,, aallll ooff sseettttiinnggss ooff tthhee ppiiccttuurree ffrraammeess w

wiillll rreevveerrtt ttoo ddeeffaauulltt sseettttiinnggss..

RReemmoottee CCoonnttrrooll

A On /Off B Rotate the picture C Skip to anterior photo. D For playing or pausing. E For switching over the frame display type. F Skip to next photo.

TOP

BOTTOM

FRONT

REAR

Page 4

ODYS DPF-Vario

G For setting the interval time of playing the photo.

AAcccceessssoorriieess

z Power adapter z Remote Control (with b attery) z 3 exchangeable Frames z Operation manual z Bracket z Warranty Card

SSttaarrtt ttoo uussee



Standing up th e Photo Frame

Insert the stand in the opening provided for it as shown. Now turn the wheel clockwise until the stand is fastened. To remove the stand, turn the wheel in the opposite direction.



Install the memory card

Insert SD / MMC /MS/card saved with photos to the card slot of the photo frame.

• Don’t change the SD / MMC/MS card while Picture Frame is powered on! If you want to change the card turn the power off at first.

• Please insert the card in a correct di rection. Do n ot apply too strong a force whe n inserting the card to prevent damaging the card or the component of digital photo frame. Please check for a correct inserting direction if it can not be done.

• Don't insert or pull out the saving card while reading information.

 Connect the power supply

Insert one end of the power adapter to the AC power socket, and the other end to the DC socket at the back of the photo frame.

 Power on

The photo frame can be turned on automatically when the photo frame is connected to the power supply.

 Power off

Page 5

ODYS DPF-Vario

5/6

Disconnect the power supply; the digital photo frame will be turned off.  Description of function It will begin to play photo automatically after power on. Press the TIME key (Remote Control) to set the interval time of playing the phot o. There are 10 opti ons of 5s, 15s, 30s, 60s, 5 minute, 15 minute, 30 minute, 45 minute, 1hour and infinite. (Note: The setting only controls interval to play pictures, excluding the time to reading pictures; and some reading time may be extended for format or size of picture) Press the MODE key to switch over the frame display type. There are 4 options of fill, original, auto fit, pan scan.

Mode Description

fill

Extend the frame to fill the whole screen

original

Zoom the frame to original size

auto fit

Automatically fit the screen subject to the upper and lower boundary of the screen

pan scan

Intercept picture automatically to display in full screen.

Press to rotate the picture (rotate by 90 degrees each ti me). Press

key to pause the play during the photo play. Press again key to resume the normal play.

Press

key under the play and pause mode to jump to the next file and play.

Press

key to jump to the previous file and play.

TTeecchhnniiccaall ppaarraammeetteerr

LCD display screen

7〞TFT LCD，480×234 pixels

File format JPEG

Storage media SD / MMC/MS card Power adapter AC110~240 input, DV 5V output.

Page 6

ODYS DPF-Vario

Warranty condition

The following conditions comprise the requ irements and scope of our warranty conditions and do not affect our legal and contractual warranty obligations.

We offer a warranty on our products in accordance with the following conditions:

1. Odys products are covered by a 24 month warranty. We will resolve damages or defects on Odys products free of charge within 12 months of the purchase date under the foll owing warrant y conditi ons. For an y damage or defec t determ ined later tha n 12 mon ths after the purchase date, proof of a manufacturing fault must be submitted for repair under warranty. The warranty does not cover batteries and other parts, which are considered consumables, parts that break easily such as glass or plastic or defects based on normal wear and tear. There is no warranty obligation in the event of marginal differences compared to the target appearance and workmanship provided these have a negligible effe ct on the product's fitness for use, in the event of damage caused by chemical or electrochemical effects, by water or generally from abnormal conditions.

2. The warranty will be performed in such a way that we shall decide whether to repair the defective parts or to rep lace them with working parts free of charge. AXDIA reserves the right to exchange the product for a replacement product of equal value if the product that is sent in cannot be repaired within a reasonable time or at reasonable cost. The product can also be exchanged for a different model of the same value. Requests cannot be made for repairs to be carried out on site. Parts that have been replaced or exchanged become our property.

3. The warranty claim does not apply if repairs or other work is carried out by unauthorized persons or if our products are equipped with additional parts or accessories that are not approved for our products.

4. Warranties that have been activated do not cause the warranty period to be extended, nor do they trigger a new warranty period. The warranty period for any replacement parts installed ends with the warranty period for the entire product.

5. Any other or further claims are excluded, especially those for replacement due to damage caused outside of the product, provided there is no obligatory legal liability. We therefore accept no liability for accidental, indirect or other consequential damage of any kind, which leads to usage restrictions, data loss, loss of earnings or interruption to business.

Asserting a warranty claim

1. To make use of the warranty service, you must contact the AXDIA Service Ce nter by e-mail, f ax or phone (see below for contact details). You can also use the service form on our website or on the back of the warranty conditions.

2. AXDIA Service Center will try to diagnose and solve your problem. If it is determined that a warranty claim exists, you will be given an RMA number (Return Material Authorization) and you will be asked to send the product to AXDIA.

IMPORTANT: AXDIA will only accept parcels that have an RMA number.

Please observe the following when sending the product:

1. Send the product su itably packaged with carriage and insurance paid. Do not enclose an y accessories with the products (no cables, CD's, memory cards, manuals, etc.), unless the AXDIA Service Centre specifies otherwise.

2. Mark the RMA number on the outside of the package in such a way that it is visible and clearly legible.

3. You must enclose a copy of the sales slip as proof of purchase.

4. Once AXDIA has received the product, it will meet its warranty obligations in accordance with the warranty conditions and will return the product to the sender with carriage and insurance paid.

Service outside of warranty

AXDIA can refuse any service claim made that is not covered by the warranty. If AXDIA agrees to provide a service outside the warranty, the customer will be invoiced for all repair and transp ort costs. AXDIA will not accept any packages that have not first been approved by AXDIA by means of an RMA (Return Material Authorization).