Odin CL-4 Connect User Manual

ODIN CL-4 Connect V1

Highlite Interna t ional B.V. – Vestastraat 2 – 6468 EX – Kerkrade – the Netherlands

Ordercode: D3915

MANUAL

ENGLISH

Ordercode: D3915

ODIN CL-4 Connect

Table of contents

Warning ............................................................................................................................................................................... 2

Safety Instructions ......................................................................................................................................................... 2

Connection with the mains ......................................................................................................................................... 4

Return Procedure .......................................................................................................................................................... 4

Claims .............................................................................................................................................................................. 4

Description of the device ................................................................................................................................................. 5

Overview ........................................................................................................................................................................ 5

Frontside .......................................................................................................................................................................... 6

Backside ......................................................................................................................................................................... 7

Installation ........................................................................................................................................................................... 8

Connection Example ................................................................................................................................................... 8

Set Up and Operation ....................................................................................................................................................... 9

Connecting a Wireless Access Point and Updating .............................................................................................. 9

Connection Cables .........................................................................................................................................................11

How to Make a Data Cable .....................................................................................................................................11

Maintenance ....................................................................................................................................................................12

Troubleshooting ...............................................................................................................................................................12

Product Specifications ....................................................................................................................................................12

Notes ..................................................................................................................................................................................13

1

Ordercode: D3915

ODIN CL-4 Connect

Your shipment includes:

Warning

Unpacking Instructions

Immediately upon receiving this product, carefully unpack the carton and check the contents to ensure
that all parts are present, and have been received in good condition. Notify the dealer immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be
returned to the factory, it is important that the fixture be returned in the original factory box and packing.

• ODIN CL-4 Connect

• 5V DC power adapter

• User manual

Safety Instructions

Every person involved with the installation, operation and maintenance of this system has to:

• be qualified

• follow the instructions of this manual

Before you initial start-up, please make sure that there is no damage caused by transportation.
Should there be any, consult your dealer and do not use the system.

To maintain perfect condition and to ensure a safe operation, it is absolutely necessary for the user to
follow the safety instructions and warning notes written in this manual.

Please consider that damages caused by manual modifications to the system are not subject to
warranty.

This system contains no user-serviceable parts. Refer servicing to qualified technicians only.

2

Ordercode: D3915

ODIN CL-4 Connect

IMPORTANT!

The manufacturer will not accept liability for any resulting damages caused by the non-observance of
this manual or any unauthorized modification to the system.

• Always disconnect power from the mains, when system is not used. Only handle the power cord by
the plug. Never pull out the plug by tugging the power cord.

• Always operate the unit with the AC ground wire connected to the electrical system ground.

• Avoid flames and do not put close to flammable liquids or gases.

• Avoid ground loops! Always be sure to connect the power amps and the mixing console to the

same electrical circuit to ensure the same phase!

• Avoid installing your equipment very near radio or TV sets, mobile phones, etc., as these can cause
RF (radio frequency) interference.

• Before changing your grounds around, always turn your amplifiers down.

• Before switching on or off, make sure that the sound system’s amplifiers are off or turned down: this

will avoid signal peaks, which are annoying and sometimes dangerous (particularly for speaker
enclosures).

• Do not connect this device to a dimmer pack.

• Do not open this device.

• Do not switch the system on and off in short intervals, as this would reduce the system’s life.

• If device is dropped or struck, disconnect mains power supply immediately. Have a qualified

engineer inspect for safety before operating.

• If the system has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your system. Leave the
system switched off until it has reached room temperature.

• Make sure that the available voltage is not higher than stated on the rear panel.

• Make sure that the power cord is never crimped or damaged. Check the device and the power

cord from time to time.

• Make sure that there is sufficient room on all sides of the system for air circulation.

• Make sure you do not use the wrong kind of cables or defective cables.

• Never let the power cord come into contact with other cables! Handle the power cord and all

connections with the mains with particular caution!

• Never remove warning or informative labels from the unit.

• Never use anything to cover the ground contact.

• Only use device indoors, avoid contact with water or other liquids.

• Please turn off the power, when changing the power cord or signal cable, or select the input mode

switch.

• Prevent distortion! Make sure that all components connected to the ODIN have sufficient power
ratings. Otherwise distortion will be generated because the components are operated at their limits.

• Repairs, servicing and electric connection must be carried out by a qualified technician.

• Sometimes, when you want to send one signal to more than one amplifier, you should use a signal

distributor.

• When connecting the other parts of your sound system, watch out for the so-called “ground loops”.

• WARRANTY: Till one year after date of purchase.

3

Ordercode: D3915

ODIN CL-4 Connect

International

EU Cable

UK Cable

US Cable

Pin

L

BROWN

RED

YELLOW/COPPER

PHASE

N

BLUE

BLACK

SILVER

NEUTRAL

YELLOW/GREEN

GREEN

GREEN

PROTECTIVE GROUND

Return Procedure

Connection with the mains

Connect the device to the mains with the power-plug.
Always pay attention, that the right color cable is connected to the right place.

Make sure that the device is always connected properly to the earth!
Improper installation can cause serious damage to people and property!

Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued.
Package must be clearly labeled with a Return Authorization Number (RMA number). Products returned
without an RMA number will be refused. Highlite will not accept the returned goods or any responsibility.
Call Highlite 0031-455667723 or mail [e-mail]
Be prepared to provide the model number, serial number and a brief description of the cause for the
return. Be sure to properly pack fixture, any shipping damage resulting from inadequate packaging is the
customer’s responsibility. Highlite reserves the right to use its own discretion to repair or replace
product(s). As a suggestion, proper UPS packing or double-boxing is always a safe method to use.

Note: If you are given an RMA number, please include the following information on a piece of paper
inside the box:

01) Your name

02) Your address

03) Your phone number

04) A brief description of the symptoms

and request an RMA prior to shipping the fixture.

Claims

The client has the obligation to check the delivered goods immediately upon delivery for any short­comings and/or visible defects, or perform this check after our announcement that the goods are at their
disposal. Damage incurred in shipping is the responsibility of the shipper; therefore the damage must be
reported to the carrier upon receipt of merchandise.
It is the customer's responsibility to notify and submit claims with the shipper in the event that a fixture is
damaged due to shipping. Transportation damage has to be reported to us within one day after receipt
of the delivery.
Any return shipment has to be made post-paid at all times. Return shipments must be accompanied with
a letter defining the reason for return shipment. Non-prepaid return shipments will be refused, unless
otherwise agreed in writing.
Complaints against us must be made known in writing or by fax within 10 working days after receipt of the
invoice. After this period complaints will not be handled anymore.
Complaints will only then be considered if the client has so far complied with all parts of the agreement,
regardless of the agreement of which the obligation is resulting.

4