Octasound RABX2 Installation Guide

To take full advantage of the feature set provided by the Octasound RABX2 it is recommended to use CAT5 for
wiring. Other methods will restrict the full capability. See page 2 and 3 for alternate wiring methods.

Wiring The Octasound - RABX2 Output

Wiring CH1 to an XLR

CAT5 Method - Single or Dual Channel

Connect to Octasound RABX2

Output Socket

AudioPower

(Rear View)

12

PWR GND PWR GND CH1+CH1- CH2 - CH2 +

Connectors Supplied

Insert a paperclip above to
release wire. If using
stranded cable insert
paperclip rst, insert wire
then remove paperclip.

+12V +12V

GND

To 12V Dc Adapter

GND

CH1 CH2

To Input of Amp, DSP, EQ

CH2 GNDCH1 GND

Wiring The Octasound - RABX2 Output

2 Conductor Shielded Cable + Power Cable

3

With RAMX2

CH1+ CH1- GND

Wiring CH1 to an 1/4’ Jack

XLR Rear View

Tip

RingSleeve

FIGURE A

Balanced Output

Wiring CH1 to an XLR

(Rear View)

Connectors Supplied

With RAMX2

Connect to Octasound RABX2

Output Socket

Power

PWR GND PWR GND CH1+CH1-

+

-

To 12V Dc Adapter

To AMP, EQ. DSP

Balanced Input

Audio

CH2 - CH2 +

BKWHSH

Insert a paperclip above to
release wire. If using
stranded cable insert
paperclip rst, insert wire
then remove paperclip.

CH1+ CH1- GND

Wiring CH1 to an 1/4’ Jack

XLR Rear View

FIGURE B

Balanced Output

12

3

Tip

RingSleeve

pg 2

Wiring The Octasound - RABX2 Output

With Only 2 Conductor Shielded Cable

Connect to Octasound RAMX2

Output Socket

Connectors Supplied

With RAMX2

Power

LINE A LINE B

PWR GND PWR GND A +A -

BKWH SH

Audio

B - B +

**** Wire shielded cable in parallel to negative power supply
And ground on unbalanced amplier input

FIGURE C

Unbalanced Output

Wiring The Octasound - RABX2 Output

Into a KDM IA330A, MI300

Power

LINE A LINE B

PWR GND PWR GND A +A -

BKWH SH

Audio

B - B +

SH

WH

BK

FIGURE D

Unbalanced Output

-

To 12 VDC Adapter

+

Sleeve

To AMP, EQ, DSP

Unbalanced Input

Tip

KDM IA330A

A B CA B CA B C

pg 2