USER MANUAL
OMX-HDMI-HDBIT
HDMI over Single Cat5/5e/Cat6 Transmission System with HDbitT Technology
812 Kings Highway · Saugerties, NY 12477
Ocean Matrix
www.oceanmatrix.com
OMX-HDMI-HDBIT
HDMI Extender
The Ocean Matrix OMX-HDMI-HDBIT extends high definition audio/
video transmission beyond the standard distances for HDMI cable
limitations via HDbitT technology. This system delivers a full 1080P
HDMI signal up to 394 feet over a single Cat5/5E/Cat6 network cable
with or without network switches, and network routers.
The system incorporates HDbitT (High Definition Digital bit Transmission Technology) protocol for better image clarity and high performance
over long distances without a converter. This technology allows signal
distribution through network switches and routers to multiple receivers
and displays without loss in image quality. Works perfectly when implemented over an IP network, allowing simple function of 1 to 1 or 1 to
multiple cascade setups.
Includes
One HDMI transmitter
One HDMI receiver
Two 5VDC power adapters
One IR blaster extension cable- 3.28 ft (1m)
One IR receiver extension cable - 3.28 ft (1m)
Specifications
Supported Resolutions 480i@60Hz, 480p@60Hz, 576i@50Hz,
576p@50Hz,720p@50/60Hz, 1080i@50/60Hz,
1080p@50/60Hz
Network Cable UTP/STP Cat5/5e/6
Transmission Range 1080p resolution up to 393 ft (120m)
IR Remote Control Supports 20-60kHz standard IR remote controls
Power Supply 5VDC/1A
Power Consumption Transmitter 3.5W, Receiver 3W
Working Temperature 32°F - 140°F (0℃- 60℃)
Dimensions (LxWxH) 3.81x3.70x0.93in (96.8x94x 23.7mm) per unit
Weight Transmitter 0.32 lb., Receiver 0.31 lb. (145g /142g)
Ocean Matrix OMX-HDMI-HDBIT Page 2
OMX-HDMI-HDBIT
Installation Requirements
1. HDMI source device such as a video camera, media player,
monitoring equipment or computer.
2. HDMI display device such as an SDTV, HDTV, or projector with
HDMI port.
3. UTP/STP Cat5e/6 network cable in accordance with the IEEE-568B
wiring standard.
4. Transmission length: Cat5-80m, Cat5e-100m, Cat6-120m.
Installation Safety
1. Identify the receiver and the transmitter in order to make proper
connections during installation.
2. Do not hot plug/swap when in operation.
3. Use 5VDC power supply only.
IR User Guide
1. Plug the IR blaster extension cable into the IR-out port of the Transmitter TX.
2. Plug the the IR receiver extension cable into the IR-IN port of the
Receiver RX.
3. Place the emitter of the IR blaster as close as possible to the IR
receiver of the signal source device.
4. Direct the IR remote controller of the signal source device towards
the IR receiver (connected to the RX of HDMI extender), to remote
control source media playback.
Ocean Matrix OMX-HDMI-HDBIT Page 3
Loading...