Oceanled Marine LTD Sport Quick Install Manual

© 2017 Ocean LED Marine LTD
All Rights Reserved

Specifications are subject to change
without notice.

Trademarks are the property of
Ocean LED Marine LTD

www.oceanled.com

Ocean LED Marine LTD

Unit 1 Jacknell Road
Dodwells Bridge Industrial Estate
Hinckley,
Leicestershire LE10 3BS
United Kingdom
Tel: [phone]
Fax: [phone]
[e-mail]

OceanLED USA
OceanLED USA LLC

778 South Military Trail
Deerfield Beach
Florida
Tel: [phone]
Fax: [phone]
[e-mail]

For full installation guide and
warranty information, go to

www.oceanled.com/Sport

or scan the QR code below:

OceanLED INSTALL GUIDE / SPORT / 170317 / v7.1

Sport

Series

Quick Install Guide

For full instructions visit
www.oceanled.com/sport

OceanLED makes every eort to protect our marine and fresh water environment
as well as our natural resources. Please take care to keep packaging away from
and out of the water by ensuring loose packaging materials are secured and not
susceptible to being blown into the water. Please recycle all packaging materials
as the sustainability of our environment is everyone’s responsibility.

WARNING: Ensure mounting location is flat and check internally for ease of access or if
there is a rib, strut, stringer or other hull

irregularity

that may interfere with the

installation.

WARNING: Never use power tools to secure your lights; hand tighten only.

WARNING: We recommend you use screws provided. If alternative screws are used, do

not use counter sunk or non flat shoulder screws to secure your lights to the hull.

WARNING: OceanLED recommends dry fitting all products. When installing, be sure
that the light fits the area and secures to the hull using the appropriate hardware
before applying any sealant.

WARNING: Light is for thru-hull mounting only. Cable and connections exposed to
underwater submersion will not be covered by warranty!

WARNING: There are several dierent hull types. Most are either solid GRP or
cored. Be sure you follow the correct procedures for the hull you are preparing
since all require dierent preparation methods. We will cover the most common
type below. If in doubt please contact your local OceanLED representative or the
boat manufacturer for assistance.

WARNING: Please check all components prior to installation. If there is any dam­age to connectors, cables, and/or any other component, please notify OceanLED
BEFORE installation. Failure to notify OceanLED of damage in transit prior to
installation will lead to violation of warranty.

WARNING: Light is for mounting directly to a flat surface on the hull, with the

cable passing through a 1/2” (12.5mm) hole in the hull. Do not submerse your

cable in water; cable and connections exposed to underwater submersion will not
be covered by warranty. Mounting the light in any other configuration, other than
those described in this guide, will invalidate its warranty.

Contents

1 x SPORT LED Light & Cable
1 x In-line fuse kit
3 x Mounting Screws
1 x Install Guide