OceanAire 2OACH1211 User Manual

ACCESSORY

INSTALLATION

INSTRUCTIONS

Unplug unit. Open lower
front door to expose con-

densate bucket.
Remove bucket.

QuicltConnect Condensate Pump

AU 20AC/OACH AIR COOLED UNITS

The Quick Connect Condensate Pump may be easily
instaIled for one job, and just as easily reinstaIl the bucket
for the next job. Our quick connect kit consists of our
speciaIly prepared and wired condensate pump, 20 feet of
3/8 plastic tubing, 2-10 inch pieces of 3/8 drain hose, 3

hose clamps, 2 plastic bushings and 2 attaching screws.

Cushion mounting

TOOLS REQUIRED:

Phillips screwdriver

(for side panel &pump brackets)
Slotted screwdriver (for hose clamp)

pad

2) Start the ftrst pump bracket mounting
~crew into the second hole located on

the left side of the bucket tray. Just turn
the screw enough to catch a few threads.

Later you will slide the bracket under it.

June 1, 2003

Line voltage molex plug
(for pump motor)

3a) There is a second drain line from the rear
coil on all heat pump models.

Use a 10 inch piece of hose (1 of 2 supplied)'
and push the drain hose over the barbed fitting

Pictured 20AC Cooling Only

7) Remove electrical tape covering pre-wired line voltage
molex plug. This plug is located on the wiring harness
above the condensate pump

8) Push large
molex plug from
the pump, into
the pre-wired
receptacle.

as shown. No hose clamp is required. Route the
other end into the condensate pump tank. [1'
this line is removed in the future, slit the plastic
drain hose over the barb to release the pressure
fit tension. It will then be easy to remove.

4) Slide the left side pump mounting bracket under the
screw started in step I. InstaIl the right side pump
bracket mounting screw into the predrilled hole on the
bucket tray. Tighten both screws firmly, but do not
over tighten.

Attach 10 inch piece 00/8 drain hose to
condensate drain using hose clamp sup-
plied. Route other end of hose into con-
densate pump tank.

HEAT PUMP ONLY

Pictured 20ACH Heating Cooling

5) Using the Phillips
screw driver, re-

move the right side
panel (viewed from
the front of the unit)
and remove the

plastic knock-out
plug as pictured.

6) From the outside of the unit, route the drain
hose into the unit through the hole. Continue
,through the partition panel bushing, located
above the compressor. Remove or cut
through the foam tape to reveal the bushing.
PuIl the drain through the partition and
~ttach it to the pump discharge fitting as

shown. Re-attach side panel.

9) Disconnect molex plug
from the low voltage

micro switch that was
used by the bucket.

1-866-6fT-AlRf (438-2473)

10) Push the low voltage.

molex from the pump
into the pre wired
molex receptacle.

Installation
complete

quickconnectcondsatepwnp