Observint Technologies BLK-CPV700RH User Manual
BLK-CPV700RH High Performance 700TVL
Extended Temperature Range Vandal-proof
CCTV Dome Camera User Manual
Products: BLK-CPV700RH
BLK-CPV700RH camera
Please read this manual before using your camera, and always follow the instructions for
safety and proper use. Save this manual for future reference.
BLK-CPV700RH_CM
12/9/13
ii
WARNING
!
Changes or modications not expressly approved by the manufacturer could void the
user’s authority to operate the equipment.
CAUTION
To prevent electric shock and risk of re hazards, do NOT use other than the specied power source.
REGULATORY NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and use in
accordance with the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause interference, in which case the user will be
required to correct the interference at his own expense.
LEGAL NOTICE
Observint Technologies (Observint) products are designed to meet safety and performance standards with the use of
specic Observint authorized accessories. Observint disclaims liability associated with the use of non-Obser vint
authorized accessories.
The recording, transmission, or broadcast of any person’s voice without their consent or a court order is strictly
prohibited by law.
Observint makes no representations concerning the legality of certain product applications such as the making,
transmission, or recording of video and/or audio signals of others without their knowledge and/or consent. We
encourage you to check and comply with all applicable local, state, and federal laws and regulations before
engaging in any form of surveillance or any transmission of radio frequencies.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks
and names or their products. Observint disclaims any proprietary interest in trademarks and trade names other than
its own.
No part of this document may be reproduced or distributed in any form or by any means without the express written
permission of Observint.
© 2013 Copyright Observint Technologies. All Rights Reserved.
11000 N. Mopac Expressway, Building 300, Austin, TX 78759
For Sales and Support, please contact your distributor.
iii
High Performance 700TVL CCTV Dome Camera User Manual
Table of Contents
SECTION 1 Introduction .......................................................................1
1.1 Features ............................................................................1
1.1.1 What’s in the box ................................................................2
1.1.2 Tools you need ..................................................................2
SECTION 2 Installation ........................................................................3
2.1 General Guidelines ...................................................................3
2.2 Mounting the camera. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
2.2.1 Camera eld of view adjustments ..................................................5
SECTION 3 OSD Software Setup .................................................................7
3.1 OSD menu tree ......................................................................7
3.2 OSD Description ....................................................................11
SECTION 4 Cleaning ..........................................................................13
SECTION 5 Specications .....................................................................14
APPENDIX A Glossary ..........................................................................16
APPENDIX B Troubleshooting ...................................................................17
B.1 IR level adjustment ..................................................................17
APPENDIX C Camera Dimensions ................................................................18
iv
Precautions
• This camera should be installed by qualied personnel only.
• There are no user serviceable parts inside.
• Do not disassemble this camera other than to make initial adjustments.
• Use a UL approved regulated 24 volt AC or 12 volt DC power supply.
• Use appropriate low voltage power cable to prevent re or electrical shock.
• Please insure that your installation area can support the weight of the camera.
Handle this camera carefully
• Do not use a strong or abrasive detergent when cleaning the camera.
• Do not install near cooling or heating devices.
• Do not install the camera in extreme temperature conditions. Use the camera in environments where temperature
is within -40 °F to 122 °F. Use adequate ventilation if a camera is installed where high temperatures may occur.
• Do not install or use the camera in an environment where the humidity is high. Very high humidity levels can
reduce image quality.
• Do not install the camera under unstable lighting conditions. Severe lighting change or icker can cause the camera
to work improperly.
• Do not touch the front lens of the camera. Be careful not to leave ngerprints on the lens or camera dome.
• Do not drop the camera or subject it to physical shocks.
• Do not expose the camera to rain or spill liquids on it. If it gets wet, wipe dry immediately. Liquids can contain
minerals that corrode the electronic components.
• Do not expose the camera to radioactivity. If exposed to radioactivity the CCD will fail.
• Do not disassemble the camera. There are no user-serviceable parts inside it.
• Do not drop the camera or subject them to physical shocks. It can cause malfunctions to occur.
• Never point the camera at a strong light, or exposing it to a spotlight or an object reecting the strong light.
Smear or blooming may occur, and it can damage the image sensor.
• Before applying power to the camera, check the power source to ensure that it is within specications.
1
High Performance 700TVL CCTV Dome Camera User Manual
SECTION 1: INTRODUCTION
SECTION 1
Introduction
This high performance extended temperature CCTV dome camera feature a very high resolution CCD sensor providing 700 TVL,
dual voltage range (24 Vac, 12 Vdc), and on-screen display (OSD) for control and setup. The BLK-CPV700RH camera features a
vandal-proof case and is weather-proof with a cold temperature range to -40 °F.
1.1 Features
• 1/3” 960H Interline CCD sensor
• 700 TVL horizontal resolution
• Vandal-proof and weather-proof (IP66 rated)
• Varifocal (2.8 ~12.0 mm)
• True Day & Night (ICR) with built-in 30 IR LEDs
• Fast shutter speed (1/60 ~ 1/100,000 sec)
• 2D Digital Noise Reduction (2D DNR)
• Adaptive Tone-curve Reproduction (ATR): provides gradation compensation to improve the contrast of subjects both low-
luminance areas and high luminance areas exist in the same picture.
• Back Light Compensation (BLC) and Highlight Compensation (HLC)
• 4-Zone Privacy Masking and Motion Detection
• Mirror / Brightness / Contrast / Sharpness / HUE / Gain image adjustments
• 12 Vdc / 24 Vac dual power
• Multilingual OSD
• Second video output for easy servicing
IR LED volume
Video test port
IR LED
OSD joystick
Cooling fan
2
Zoom
adjustment
Focus
adjustment
BLK-CPV700RH zoom - focus adjustment knobs
1.1.1 What’s in the box
Your camera includes the following:
• Camera assembly
• Four (3) coarse-threaded screws and wall inserts to secure the base to the mounting surface
• Torx® (T-20) L-wrench for removing the dome
• Surface mounting template
• Video test port to BNC adapter cable
• This manual
1.1.2 Tools you need
To install the camera, you will need:
• 12 Vdc or 24 Vac power source
• Tools for mounting the camera
• Plillips #2 screwdriver
• Video and power extension cables, if needed
• Hand-held CCTV video setup monitor (optional)
SECTION 1: INTRODUCTION
3
High Performance 700TVL CCTV Dome Camera User Manual
SECTION 2
Installation
2.1 General Guidelines
The camera can be mounted on a at surface (surface mounted, usually on a ceiling). The camera drop cable can be routed through
a hole in the ceiling, or through a cable channel on the side of the camera base.
Following are some general guidelines for installing the camera.
• Camera Lens: Handle the camera dome carefully to prevent scratching or soiling the dome and lens. If the dome or lens
becomes soiled, clean it only with approved products. See the Cleaning section later in this manual.
• Monitor impedance: Set the monitor impedance switch to 75Ω.
• Power supply: To avoid re or shock hazard, use only a UL listed power supply.
• Camera drop cable: The camera drop cable includes two connectors:
— Power connector (red sleeve) – Use 24 Vac power source (AC24V 1A adapter) or 12 Vdc power source (DC12V 1A
adapter). When connecting 12 Vdc power to the camera power drop. When connecting 12 Vdc power to the drop cable
connector, observe the polarity - the center tap must be positive compared to the outer shield.
— Video coax connector (BNC, yellow sleeve) – for transmission of the video signal across coax (75 Ω) cable.
Video BNC
connector
Power
connector
Drop cable
channel
Drop cable
Video (yellow) and power (red) drop cable connectors
2.2 Mounting the camera
The camera can be mounted onto an electrical box, mounting bracket, or at surface with sucient strength to support it.
SECTION 1: INTRODUCTION
Loading...