MODEL 1020-RAB-PMK
Installation Instructions
**** WARNING ****
Please thoroughly read the product warning
below before installation to provide for a safe
work environment.
1. Always consider the hazard to other people:
a. During installation, use warning signs, etc.
b. Don’t work with people directly below the work area as equipment
could fall and cause an injury
2. Be sure to securely fasten the enclosure to the wall or ceiling to prevent
the enclosure from becoming dislodged.
Installation Instructions
Model 1020-RAB-PMK
(877) 867-2312 • www.oberonwireless.com
Part Number 2866, 10/12/2016 Oberon, Inc. •••• 1315 South Allen Street •••• State College, PA 16801 Copyright 2014
Figure 2 - Right Angle Bracket
Figure 3 - Enclosure Install
Assembly Components:
- Polycarbonate Enclosure – 1 each
- Right Angle Bracket – 1 each
- T-Bar Bracket – 1 each
- Pole Mount Bracket – 1 each
- M4x0.7 x 10 screw – 4 each
- M4x0.7 x 20 screw – 4 each
- #6 - 32 x 1/4" screw – 4 each
- #6 - 32 x 7/8" screw – 2 each
- Nylon Spacer – 2 each
- Worm Gear Clamp – 2 each
- #10-32 x 3/8 screw – 4 each
If any of these items are missing, contact your Oberon representative.
Step 1 – Slide the Worm Gear Clamps through the sl ots of the
Pole Mount Bracket, and fasten the clamps around the pole
(Figure 1). Note, the included clamps only work for poles ranging
from 5 inches to 9 inches diameter.
Step 2 – Fasten the Right Angle Bracket to the Pole
Mount Bracket using the provided #10 screws (Figure
3).
Step 3 – Fasten the enclosure to the Right Angle Brac ket
with the provided M4 x 10mm screws.
Step 3 – Route any cabling as needed, and install t he
access point with the provided #8 plastic screws. A se t of
nylon spacers and longer screws are provided to inc rease
the height of the T-Bar if necessary. Screw on the co ver to 8
in-lbs for a proper seal using the provided M4 x 20m m self
captured screws (Figure 3). Installation is complete.
Figure 1 - Pole Mounting Bracket
Figure 4 - Access Point Install
Loading...