Oberon 1010-00 User Manual

Installation Instructions

Model Number 1010-00

Assembly Components:

- Right angle wall mount – 1 each

- 1” Flexible rubber grommet – 1 each

- #8 - 32 screw (for attaching access point mounting plate) – 4 each

- Installation Instructions – 1 each

If any of these items are missing, contact your Oberon representative.

Find a flat work surface to assemble the mount, access point’s mounting plate, conduit clamp(s), T-bar clip, and antenna(s)
prior to mounting on wall.

Step 1 – Place the mount assembly on the work surface.

Figure 1

Figure 2

Step 2a (Cisco Access Points Only) – Use the
legend on the back page to determine which hole
pattern to use (Figure 4). Securely fasten the
access point’s mounting bracket to the mount
using the included (4) # 8-32 screws (Figure 1).

Step 3 – If applicable, install the conduit clamp(s). Clamps can be installed on either side of the mount or the cover by
removing the ½” trade size knockout punch.

The mount is now ready for wall mounting.

Page 2

Step 2b (Other Manufacturers) – Fasten the
provided T-Bar bracket in the best position for the
access point, then securely fasten the access
point and its respective mounting plate or bracket

Step 4 – Place the mount on the wall where it is to
be installed (it is recommended that you mount
directly to a stud if possible) and mark the screw
locations. Use a minimum of two (2) #10 x 2” or
larger screws (not included) to secure the mount
in place. However, if there is no stud at the
mounting location, it is recommended that you use
a minimum of 4 suitable anchors to secure the
mount in place (Figure 3).

Step 5 – Run the data and power cable (if
required) through the conduit clamp located on
sides of the mount. The mount has a cutout in it
that can accommodate a wall plate for data
termination. Run data and power cable (if
required) through the flexible rubber grommet.

Step 6 – Attach the data and power cables to the
access point prior to securing the access point to
the mounting bracket. After the access point is
secured to the mounting bracket, attach antennas
to the access point if required.

**IMPORTANT** - It is important that the

mount is securely fastened to the wall to
prevent human injury or damage to the access
point.

Page 3

Figure 3

[phone] • www.oberonwireless.com

P/N 2181 – Rev. 07/30/2014 Oberon, Inc. • 1315 South Allen Street • State College, PA 16801 Copyright 2011

MODEL 1010-00

Installation Instructions

**** WARNING ****

Please thoroughly read the product warning

Page 4

Figure 4

below before installation to provide for a safe

work environment.

1. Always consider the hazard to other people:
a. During installation, use warning signs, etc.

b. Don’t work with people directly below the work area as equipment

could fall and cause an injury

2. Be sure to securely fasten the mount to the wall to prevent the mount

from becoming dislodged.

Page 1