Oatey 30203, 30204, 30205 DATA SHEET
MSDS No: OTH110C14
Issue Date: 03 Apr 2014
Page: 1 of 4
MATERIAL SAFETY DATA SHEET
SECTION 1 PRODUCT AND COMPANY IDENTIFICATION
Trade Name: OATEY DARK THREAD CUTTING OIL
Product No.: 30203, 30204, 30205
Product Use: Oil for thread cutting
Formula: Not available
Synonyms: Thread cutting oil
Firm Name & OATEY CO. 4700 West 160th Street P.O. Box 35906 Cleveland,
Mailing Address: Ohio 44135, U.S.A. http://www.oatey.com
Oatey Phone Number: (216) 267-7100 or (800) 321-9532
Emergency Phone For Emergency First Aid call 1-303-623-5716 COLLECT. For
Numbers: chemical transportation emergencies ONLY, call Chemtrec at
1-800-424-9300. Outside the U.S. 1-703-527-3887.
Prepared By: Oatey Technical Department
Preparation Date: April 03, 2014
SECTION 2 COMPOSITION/INFORMATION ON INGREDIENTS
INGREDIENTS: %wt/wt: CAS NUMBER: ACGIH TLV TWA: OSHA PEL TWA: OTHER:
Petroleum hydrocarbon 100% Mixture 5 mg/m3 5 mg/m3 None
Mixture
OSHA Hazard Classification: Not hazardous.
SECTION 3 HAZARDS IDENTIFICATION
Emergency Overview:
Transparent amber fluid. Mild eye, skin, inhalation and ingestion irritant.
SECTION 4 FIRST AID MEASURES
CALL 1-303-623-5716 COLLECT
Skin: Remove contaminated clothing immediately. Wash all exposed areas with
soap and water. Get medical attention if irritation develops.
Eyes: If material gets into eyes or if fumes cause irritation, immediately
flush eyes with plenty of water until chemical is removed. If
irritation persists, get medical attention immediately.
Inhalation: If respiratory irritation develops, remove to fresh air. If breathing
becomes difficult, administer oxygen. Administer artificial
respiration if breathing has stopped. Seek immediate medical attention.
Ingestion: DO NOT INDUCE VOMITING. Never give anything by mouth to a person who is
unconscious or drowsy. Get immediate medical attention by calling a
Poison Control Center, or hospital emergency room. If medical advice
cannot be obtained, then take the person and product to the nearest
medical emergency treatment center or hospital.
MSDS No: OTH110C14
Issue Date: 03 Apr 2014
Page: 2 of 4
SECTION 5 FIRE FIGHTING MEASURES
Flashpoint / Method: 325 Degrees F (163 Degrees C) / C.O.C.
Flammability: LEL = Not available, UEL = Not available
Extinguishing Use dry chemical, CO2, or foam to extinguish fire.
Media:
Special Fire Firefighters should wear positive pressure self-contained
Fighting breathing apparatus and full protective clothing for fires in
Procedure: areas where chemicals are used or stored
Unusual Fire and
Explosion
Hazards: None
Hazardous
Decomposition
Products: Combustion will produce oxides of carbon, phosphorus and
sulfur, hydrogen chloride and smoke.
SECTION 6 ACCIDENTAL RELEASE MEASURES
Spill or Contain spill, stop source of leak, pump spilled material into salvage
Leak container, soak up remaining material with absorbent such as sand or
Procedures: clay. Prevent product from entering potable or natural water systems.
SECTION 7 HANDLING AND STORAGE
Handling: Avoid prolonged and repeated skin contact. Launder contaminated
clothing before reuse.
Storage: Store away from direct heat source and strong oxidizing agents.
Other: Do not pressurize, cut, weld, braze, drill, grind or heat empty
containers as some flammable, hazardous or combustible residue may be
present. Avoid breathing mist. For industrial use only.
SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION
Ventilation: Recommended to maintain mist below TLV limit.
Respiratory For operations where the exposure limit may be exceeded, a NIOSH
Protection: approved organic vapor respirator or supplied air respirator is
recommended. Equipment selection depends on contaminant type and
concentration, select in accordance with 29 CFR 1910.134 and good
industrial hygiene practice.
Skin
Protection: Oil/Chemical resistant gloves to minimize skin contact.
Eye Splash protection.
Protection:
Other: Eye wash and safety shower should be available.
SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point: 500 Degrees F / 260 Degrees C
Melting Point: Not applicable
Vapor Pressure: Not available
Vapor Density: Not available
Volatile Components: Nil.
Solubility In Water: Slight
pH: Not applicable
Specific Gravity: 0.93 @ 20 Degrees C
Evaporation Rate: Not available
Appearance: Transparent amber fluid
Odor: Mild petroleum
Will Dissolve In: Oil and organic solvents
Material Is: Liquid
Loading...