Oatey 2824 User Manual

SAFETY DATA SHEET

1. Identification

UNI-WELD PVC Regular Clear Fast Set CementProduct identifier

Other means of identification

Product code

Synonyms
Recommended use
Recommended restrictions
Manufacturer/Importer/Supplier/Distributor information

Company Name

Address

Telephone

E-mail

Transport Emergency

Emergency First Aid

Contact person

2113E
Part Numbers: 2866S, 2856S, 2846S. 2836S, 2824
Joining PVC Pipes
None known.

United Elchem Industries c/o Oatey Co.
4700 West 160th Street
Cleveland, OH 44135
216-267-7100
[e-mail]
Chemtrec 1-800-424-9300 (Outside the US 1-703-527-3887)
1-877-740-5015
MSDS Coordinator

2. Hazard(s) identification

Physical hazards
Health hazards

OSHA defined hazards
Label elements

Signal word

Hazard statement

Precautionary statement

Prevention

Response

Category 2Flammable liquids
Category 4Acute toxicity, oral

Category 2Skin corrosion/irritation
Category 2ASerious eye damage/eye irritation
Category 3 respiratory tract irritationSpecific target organ toxicity, single exposure
Category 3 narcotic effectsSpecific target organ toxicity, single exposure
Category 1Aspiration hazard

Not classified.

Danger
Highly flammable liquid and vapor. Harmful if swallowed. May be fatal if swallowed and enters

airways. Causes skin irritation. Causes serious eye irritation. May cause respiratory irritation. May
cause drowsiness or dizziness.

Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Keep container tightly
closed. Ground/bond container and receiving equipment. Use explosion-proof
electrical/ventilating/lighting equipment. Use only non-sparking tools. Take precautionary
measures against static discharge. Avoid breathing mist or vapor. Wash thoroughly after
handling. Do not eat, drink or smoke when using this product. Use only outdoors or in a
well-ventilated area. Wear protective gloves/protective clothing/eye protection/face protection.

If swallowed: Immediately call a poison center/doctor. If on skin (or hair): Take off immediately all
contaminated clothing. Rinse skin with water/shower. If inhaled: Remove person to fresh air and
keep comfortable for breathing. If in eyes: Rinse cautiously with water for several minutes.
Remove contact lenses, if present and easy to do. Continue rinsing. Call a poison center/doctor if
you feel unwell. Rinse mouth. Do NOT induce vomiting. If skin irritation occurs: Get medical
advice/attention. If eye irritation persists: Get medical advice/attention. Take off contaminated
clothing and wash before reuse. In case of fire: Use appropriate media to extinguish.

UNI-WELD PVC Regular Clear Fast Set Cement SDS US
927039 Version #: 01 Revision date: - Issue date: 05-27-2015

1 / 10

Storage
Disposal

Hazard(s) not otherwise
classified (HNOC)

Supplemental information

Not applicable.

Store in a well-ventilated place. Keep container tightly closed. Keep cool. Store locked up.
Dispose of contents/container in accordance with local/regional/national/international regulations.
Frequent or prolonged contact may defat and dry the skin, leading to discomfort and dermatitis.

May form explosive peroxides. Contains a chemical classified by the US EPA as a suspected
possible carcinogen.

3. Composition/information on ingredients

Mixtures

CAS number %Chemical name

109-99-9 25-40Furan, Tetrahydro-

78-93-3 25-40Methyl ethyl ketone
67-64-1 10-25Acetone

108-94-1 10-25Cyclohexanone

9002-86-2 10-25Polyvinyl chloride

*Designates that a specific chemical identity and/or percentage of composition has been withheld as a trade secret.

4. First-aid measures

Inhalation

Skin contact

Eye contact

Ingestion

Most important
symptoms/effects, acute and
delayed

Indication of immediate
medical attention and special
treatment needed

General information

Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON
CENTER or doctor/physician if you feel unwell.

Take off immediately all contaminated clothing. Wash with plenty of soap and water. If skin
irritation occurs: Get medical advice/attention.

Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if
present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.

Call a physician or poison control center immediately. Do not induce vomiting. If vomiting occurs,
keep head low so that stomach content doesn't get into the lungs. Aspiration may cause
pulmonary edema and pneumonitis.

Irritation of nose and throat. Aspiration may cause pulmonary edema and pneumonitis. Severe eye
irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred vision. May
cause respiratory irritation. Vapors have a narcotic effect and may cause headache, fatigue,
dizziness and nausea. Skin irritation. May cause redness and pain.

Provide general supportive measures and treat symptomatically. Thermal burns: Flush with water
immediately. While flushing, remove clothes which do not adhere to affected area. Call an
ambulance. Continue flushing during transport to hospital. In case of shortness of breath, give
oxygen. Keep victim warm. Keep victim under observation. Symptoms may be delayed.

Take off all contaminated clothing immediately. Ensure that medical personnel are aware of the
material(s) involved, and take precautions to protect themselves. Wash contaminated clothing
before reuse.

5. Fire-fighting measures

Suitable extinguishing media
Unsuitable extinguishing

media
Specific hazards arising from

the chemical
Special protective equipment

and precautions for firefighters
Fire fighting

equipment/instructions
Specific methods
General fire hazards

UNI-WELD PVC Regular Clear Fast Set Cement SDS US
927039 Version #: 01 Revision date: - Issue date: 05-27-2015

Alcohol resistant foam. Water fog. Dry chemical powder. Carbon dioxide (CO2).
Do not use water jet as an extinguisher, as this will spread the fire.

Vapors may form explosive mixtures with air. Vapors may travel considerable distance to a source
of ignition and flash back. During fire, gases hazardous to health may be formed.

Self-contained breathing apparatus and full protective clothing must be worn in case of fire.

In case of fire and/or explosion do not breathe fumes. Move containers from fire area if you can do
so without risk.

Use standard firefighting procedures and consider the hazards of other involved materials.
Highly flammable liquid and vapor. This product contains tetrahydrofuran that may form explosive

organic peroxide when exposed to air or light or with age.

2 / 10

6. Accidental release measures

Personal precautions,
protective equipment and
emergency procedures

Methods and materials for
containment and cleaning up

Environmental precautions

Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of
low areas. Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area).
Wear appropriate protective equipment and clothing during clean-up. Avoid breathing mist or
vapor. Do not touch damaged containers or spilled material unless wearing appropriate protective
clothing. Ventilate closed spaces before entering them. Local authorities should be advised if
significant spillages cannot be contained. For personal protection, see section 8 of the SDS.

Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Take
precautionary measures against static discharge. Use only non-sparking tools. Keep combustibles
(wood, paper, oil, etc.) away from spilled material. This product is miscible in water.

Large Spills: Stop the flow of material, if this is without risk. Use water spray to reduce vapors or
divert vapor cloud drift. Dike the spilled material, where this is possible. Cover with plastic sheet to
prevent spreading. Use a non-combustible material like vermiculite, sand or earth to soak up the
product and place into a container for later disposal. Prevent entry into waterways, sewer,
basements or confined areas. Following product recovery, flush area with water.

Small Spills: Absorb with earth, sand or other non-combustible material and transfer to containers
for later disposal. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.

Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Avoid discharge into drains, water courses or onto the ground.

7. Handling and storage

Precautions for safe handling

Conditions for safe storage,
including any incompatibilities

Vapors may form explosive mixtures with air. Do not handle, store or open near an open flame,
sources of heat or sources of ignition. Protect material from direct sunlight. Explosion-proof
general and local exhaust ventilation. Take precautionary measures against static discharges. All
equipment used when handling the product must be grounded. Use non-sparking tools and
explosion-proof equipment. Avoid breathing mist or vapor. Avoid contact with eyes, skin, and
clothing. Avoid prolonged exposure. Do not taste or swallow. When using, do not eat, drink or
smoke. Wear appropriate personal protective equipment. Wash hands thoroughly after handling.
Observe good industrial hygiene practices.

Store locked up. Keep away from heat, sparks and open flame. Prevent electrostatic charge
build-up by using common bonding and grounding techniques. Store in a cool, dry place out of
direct sunlight. Store in original tightly closed container. Store in a well-ventilated place. Store
away from incompatible materials (see Section 10 of the SDS).

8. Exposure controls/personal protection

Occupational exposure limits

US. OSHA Specifically Regulated Substances (29 CFR 1910.1001-1050)

TypeComponents

STEL 5 ppmPolyvinyl chloride (CAS

9002-86-2)

TWA 1 ppm

US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)

Components

108-94-1)

109-99-9)

78-93-3)

9002-86-2)

Type

PEL 2400 mg/m3Acetone (CAS 67-64-1)

PEL 200 mg/m3Cyclohexanone (CAS

PEL 590 mg/m3Furan, Tetrahydro- (CAS

PEL 590 mg/m3Methyl ethyl ketone (CAS

PEL 5 mg/m3 Respirable fraction.Polyvinyl chloride (CAS

Value

Value

1000 ppm

50 ppm

200 ppm

200 ppm

15 mg/m3 Total dust.

Form

UNI-WELD PVC Regular Clear Fast Set Cement SDS US
927039 Version #: 01 Revision date: - Issue date: 05-27-2015

3 / 10