Oasis Concepts ML-3050, Dell 1815dn MFP User Manual

Samsung ML-3050 / Dell 1815dn MFP

Oasis Imaging Products, Inc. Technical Support: 800- 322- 8992 ext 110

Reference Information:
OEM Cartridge Yield @ 5% Tools Required

Standard 4000 Phillips Screwdriver
High Yield 8000 Small Flathead Screwdriver
Needle Nose Pliers

Supplies Required

Toner
Drum
Wiper Blade
Chip

1. Place the unit on a work bench with the OPC
drum facing up. Using a small flathead
screwdriver, pry off the axle bearing bushing
drum lock. Repeat process on opposite side
(Fig. 1).

2. Using a Phillips screwdriver, remove the three
screws on the contact side end cap (Fig. 2).

Fig. 1

Fig. 2

Samsung ML-3050 / Dell 1815dn MFP 1

3. Using a small flathead screwdriver, depress
the locking tab to release the contact side end
cap (Fig. 3).

4. Pry off the contact side end cap using a
flathead screwdriver (Fig 4).

Fig. 3

Fig. 4

5. Contact end cap configuration (Fig. 5).

Fig. 5

6. Remove the doctor blade contact spring
using needle nose pliers (Fig. 6). Note spring
configuration for reassembly.

Fig. 6

Samsung ML-3050 / Dell 1815dn MFP 2

Fig. 7

7. Using a Phillips screwdriver, remove the three
screws on the gear side end cap (Fig. 7).

8. Using a small flathead screwdriver, depress
the locking tab on the gear side end cap (Fig. 8).
Pry off the end cap as in step 4.

9. Remove the PCR cleaning roller housing
and clean the roller with compressed air and
vacuum
(Fig. 9).

10. Spread tabs apart on both sides of the
cartridge while lifting on the OPC drum axle to
separate the toner hopper from the waste
hopper (Fig. 10).

Fig. 8

Fig. 9

Fig. 10

Samsung ML-3050 / Dell 1815dn MFP 3