Page 1
Neptun
1600, 2600
Warranty, Safety and
Operating Instructions
27852/08B
Page 2
Technical Data
Type Dimensions Weight Rated voltage Power consumption Max. Flow Rate Max. Head Height Immersion depth Connections Cable length
Type D im ensions Poids Tension nom inale Puissance ab s orbée Capacité de
refoulement
Colonne d'eau Profondeur
d'immersion
Raccordements Longueur de câble
Tipo Dimensi ones Peso Tensión nominal Consumo de
potencia
Capacidad de
elevación
Columna de agua Profundidad de in-
mersión
Conexiones Longitud del cable
Neptun
1600
340 x 160 x 160 mm
13.4 x 6.3 x 6.3 in ch
3.0 kg / 6.6 lbs.
110-120 V, 60 Hz
100 W
1,600 Gph. max. 4.7 m, 15.4 ft
max. 4 m, 13.0 ft 1.5"
6 m
20.0 ft
3.5 kg / 7.0 lbs.
220 W
2,600 Gph. m ax. 6 m, 20.0 ft
2600
12345
Motor casing Pressure socket
Flow regulator/suction unit
Pre-filter Pump foot
Bloc moteur Raccord de tuyau de refoulement
Régulateur de débit/unité d'aspiration
Tamis préfiltre Pied de la pompe
Bloque del motor Tubuladura de presión
Regulador volumétrico de paso / unidad de
aspiración
Filtro previo Pie de la bomba
4
3
2
1
5
Page 3
A
B
C
D
2
Page 4
4
Safety and Operating Instructions
OASE Neptun 1600-2600
Thank you for purchasing an OASE water feature pump. OASE pumps were developed through extensive research and
are known world wide for their high-quality construction, energy-efficiency, and environmental s afety features. OASE water feature pumps do not contain any oil, instead they are cooled and lubricated by water only. Please read the following
instructions carefully and thoroughly. Failure to comply with these requirements may result in pump damage or failure,
and could cause serious or fatal injury. Close attention to these guidelines will result in many years of pleasure from your
OASE pump.
Operational Range
Application:
- Outdoor use
- Koi (Japanese carp species) fish basins
- Garden ponds
- Water Features
- The pump is suitable for the conveyance of water from garden ponds and fish basins and can be used with various water
features.
- This product is not intended for use by children without proper supervision.
- Keep out of the reach of children.
Water Temperature Range:
- 40-85 degrees Fahrenheit (4-35 °C)
Maximum Water Depth:
- 13 ft (4.0 m)
Safety Instructions (S 1)
- Check that the electrical data of the power supply network and that on the type plate coincide.
- Only con n ec t th e pu mp t o a gr ou n de d po we r outlet (GFI) in accordance with the valid local or national electrical codes
(NEC, UL, CSA, IEC...). Contact a qualified electrician with any questions.
- Do not use additional components, extension or connection cables or adapters, which are not grounded.
- Never operate the pump while people are in the water.
- Make sure that garden ponds meet the local and national installation regulations. Contact a qualified electrician!
- Remove the power cable from the electrical socket prior to handling the pump.
- Note! In the event of a fault, a maximum of 10 switch-on/off cycles are carried out. Should this prove unsuccessful, the
pump will switch off after approx. 40 seconds. Remove the power plug from the electrical socket and clean pump if necessary.
- Never carry or pull the pump by the power cord.
- Always keep the connection points (power plug) dry.
- Do not operate the pump if cable or casing shows any signs of damage.
- Lay the connection cable suc h that it is protected agains t possible damage.
- To avoid potentially dangerous situations, only the manufacturer is allowed to make repairs or cable replacements.
CAUTION: This pump is for garden use. Do not use in swimming pools, spas, hot tubs, etc. Running dry will inevitably
cause almost immediate failure and void all warranties implied or otherwise.
Electrical Requirements (S 2)
WARNING: OASE pumps MUST be connected to a properly grounded and GFCI (Ground Fault Circuit Interrupter
< 30mA) protected 110-120 Volt AC circuit only. OASE Neptun p umps are equipped with a 20-foot 3-p rong electrical cord.
If the electrical cord provided is not sufficient we suggest that you consult a certified electrician and have them install an
additional GFCI outlet within reach of the cord. Consult your local power authority for electrical codes or requirements.
Avoid excessive flexing of or abrasion to the electrical cord. Any alteration to an OASE pump will result in non-compliance
with UL and Canadian UL listings and requirements. In such instances all warranties implied or otherwise are deemed
immediately void.
WARNING (S 3):
Risk of el ectr ic sh ock - This pump is su ppli ed wi th a grou nding c ondu ctor and groun ding -type att achm ent pl ug.
To reduce th e risk o f el ect ri c sh ock, b e cert ai n th a t it i s co nne c te d o nly t o a pr op erly g rou nd ed , gro un ding -t yp e
receptacle.
Do’s and Don’ts (S 4, S 5)
- Do disconnect the plug from the receptacle before moving or cleaning the pump.
- Do disconnect the plug from the receptacle before entering the water area.
- Do have all electrical outlets installed and serviced by a licensed electrician.
- Do disconnect the pump from the electrical outlet at the first sign of any problem.
- Don’t use the pump when there are people in the water.
- Don’t cut the cord or remove the plug from the cord.
- Don’t remove the grounding pin from the plug.
- Don’t carry or pull the pump by the electrical cord.
- Don’t use extension cords.
English
Page 5
5
- Don’t attempt to open the pump/motor enclosure.
- Don’t remove any labels from the pump or electrical cord.
- Don’t pinch, twist or damage the electrical cord. A minor cut even if only in the outer shell could allow water to reach
the motor enclosure and damage the pump. If you notice any damage to the cord remove the pump and store in a dry
place. Consult your local OASE Dealer for further instructions. Please note that any damage to the electrical cord will
void all warranties and could cause serious electrical shock hazard.
Installation
The unit can be set up either submerged (A).
General preparatory work: Bolt on the suction unit (3) and fit the pressure socket (2). Connect the desired hose for the
water feature to the pressure socket. Adapt stepped hose connectors to the water supply and return in accordance with
the hose diameter (B). Remove the pump foot, if necessary. For this purpose, press the pump foot to the rear, as
illustrated (C).
Submerged installation (A)
Operation with the pre-filter fitted. Push the pre-filter over the suction unit and fasten the filter using the bayonet closure.
Place the unit in the water at the desired position. Ensure that the unit is fully submerged. Maximum installation depth:
12 ft.
Switching on, star ting up
It is important to adhere to the safety instructions.
Attention! Never operate the unit without water or without pump filter!
The unit switches on automatically when connected to power.
Height and shape of the fountain depen ds on the noz zle
used.
The power supply must be disconnected to switch off the uni t.
Maintenance and cleaning
Attention! Always disconnect the power supply prior to starting cleaning and maintenance work!
For cleaning, take the unit out of the water and clean the pre-filter and the suction unit.
Storage/Over-wintering
The unit is of frost-proof design and may stay in the water over the winter. Should you choose to take the unit out of the
water, then stor e it in a water filled contain er (D). Do not immerse the plug!
Disposal
Dispose of the unit in accordance with the national legal regulations.
Malfunctions
Never open the housing! Only allow a qualified electrician to replace the power cable!
Limited Warranty (S 6)
This OASE Neptun pump is covered by a 3-year limited warranty by OASE. The limited warranty period begins fr om the
date of purchase and covers material and manufacturing defects or failure of the product to operate as specified by OASE
during the duration of the limited warranty period.
This limited warranty does not cover failure or problems related to:
- Improper installation see this manual for proper installation procedures.
- Modification of the product in any way including attempts to repair the product by someone other than an OASE trained
and authorized repair tech ni cian .
- Failure to follow proper safety, care and maintenance guidelines as outlined in this manual.
It also does not cover those parts of the product that are subject to normal wear and tear during usage of the product,
such as:
- Impellers on pumps
- Filter pads and filter medium in filters
- Lamps in lights and UV clarifiers
Trouble shooting Cause Remedy
Unit does not run - no ma ins voltage
- rotor blocked
- check mains voltage
- rinse the vane fr om the front
Insufficient fountain
height
- regulator closed too far
- filter housing soiled
- air in the hose
- rotor soiled
- hose blocked o r defective
- hose kinked
- rotor worn
- filter clogged
- set regul ator
- clean filter housing
- vent hoses
- clean
- clean hose or replace
- check hose and replace if necessary
- replace r ot or
- clean filter
After a short period of
operation the unit
switches off
- water temperature to o high - note maximum water tempe rature of +35 °C,
(85 degrees Fahrenheit)
English
Page 6
6
OASE's sole liability shall be to replace or repair the product covered by this limited warranty. OASE shall not be liable
for any consequential damage to any other part of the water garden, pond, water feature, landscape, structure, or the
contents of any structure where the product is located or used including no liability for damage or harm to fish, animals,
or plants in or around the water garden, pond or water feature.
THE EXPRESS WARRANTIES SET FORTH HEREI N ARE T HE ONLY WARRANTIES WITH RESP ECT T O THE PRO DUCTS, AND THE REMEDIES SET FORTH HEREIN ARE THE EXCLUSIVE REMEDIES IN THE EVENT OF A BREACH OF SUCH WARRANTIES. OASE EXPRESSLY DISCLAIMS ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE. OASE SHALL NOT BE LIABLE UNDER ANY CIRCUMSTANCES FOR
INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY NATURE, FOR ANY BREACH OF SUCH WARRANTIES OR
OTHERWISE. Some states do not allow the exclusion or limitation of incidental or consequential damages, to the above
limitation may not apply to you.
Should your OASE product be defective or fail under the terms of this limited warranty, you should return the product to
your OASE dealer, along with your original receipt of purchase and any other limited warranty documentation you have,
for replacement or repair.
Should you have any question about this limited warranty, please contact OASE at [email protected]
Extension of limited warranty period:
Please fill out this OASE Limited Warranty Registration Card or go online to http://www.oase-livingwater.com/ for a
2-year extension of your limited warranty. Once your registration information has been received by OASE you will receive
back by email or post a Limited Warranty Extension Certificate which you should print out an d keep wit h your original
receipt of purchase.
English
Page 7
OASE
400 E. Parkridge Avenue, Unit 101
Corona, CA 92879
www.oase-livingwater.com
Pos 1600 2600
1 35767 28432
23580 3594
3 26002 26003
4 34949 34961
5 19491 19491
6 26405 26405
7 35174 35252
8 23642 25218
2
3
4
1
765
8
Attention!
Read the operating instructions!
Attention !
Lire la notice d'emploi !
¡Atención!
Lea las instrucciones de uso
Loading...