Oase AQUARIUS UNIVERSAL 180, AQUARIUS UNIVERSAL 370, AQUARIUS UNIVERSAL 80 Operating Instructions Manual
AQUARIUS UNIVERSAL 80/180/370
Operating instructions
Instrucciones de uso
Notice d’emploi
1 2 3 4 5 6
GB
ES
FR
GB
ES
FR
Aquarius
Universal
GB
Dust tight. Submersible to
3.3 ft (1 m) depth.
ES
A prueba de polvo.
Impermeable al agua
hasta 3.3 ft (1 m) de
profundidad
FR
Imperméable aux poussières. Etanche à l'eau
jusqu'à une profondeur de
1 m
Control lever Cover Foam filter Rotor Pump housing Cable lead to sockest
Palanca de control Cubierta Elemento de espuma
Levier de contrôle Recouvrement Mousse filtrante Rotor Carter de pompe Conduite de câble vers
Type Rated voltage Power con-
Tipo Tensión asignad Consumo de
Type Tension de
mesure
sumption
potencia
Puissance
absorbée
80 4 W
AC 120 V, 60 Hz
180 8 W
370
Remove the unit at
temperatures below zero
(centigrade).
Desinstale el equipo en
caso de heladas
Retirer l’appareil en cas
de gel
22 W
filtrante
Max. flow
rate
Capacidad de
elevación
Capacité de
refoulement
≤ 80 gph
300 l/h
≤ 180 gph
680 l/h
≤ 370 gph
1400 l/h
Possible hazard for
persons wearing pace
makers!
Posibles peligros para las
personas con marcapasos.
Dangers possibles pour
des personnes ayant des
stimulateurs cardiaques !
Max.
head
height
Columna
de agua
Colonne
d'eau
≤ 1.5 ft
0.45 m
≤ 4.9 ft
1.5 m
≤ 7.7 ft
2.3 m
Rotor Carcasa de la bomba Guía de cables al
Immersion
depth
Profundidad de
inmersión
Profondeur
d'immersion
Cable length Weight Water
Longitud del
cable
Longueur de
câble
6.6 ft / 2 m
≤ 3.3 ft.
Protect from direct sun
radiation.
Protéjase contra la
radiación directa del sol.
Protéger contre les rayons
directs du soleil.
1 m
15 ft / 5 m
Peso Temperatura
Poids Température
0.9 lbs
0.4 kg
2.2 lbs
1.0 kg
2.6 lbs
1.2 kg
Attention!
Read the operating
instructions
¡Atención!
Lea las instrucciones de
uso
Attention !
Lire la notice d'emploi
tomacorriente
+4 … +35 °C
la prise
temperature
del agua
de l’eau
39 … 95 °F
2
3
- English -
- English -
Information about these operating instructions
Welcome to OASE Living Water. You made a good choice with the purchase of this product Aquarius Universal.
Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself with the unit.
Ensure that all work on and with this unit is only carried out in accordance with these instructions.
Please strictly follow the enclosed instructions to ensure safe and correct handling of the product.
Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on to a new
owner.
Symbols used in these instructions
The symbols used in this operating manual have the following meanings:
Risk of injury to persons due to dangerous electrical voltage
This symbol indicates an imminent danger, which can lead to death or severe injuries if the appropriate measures are not taken.
Risk of personal injury caused by a general source of danger
This symbol indicates an imminent danger, which can lead to death or severe injuries if the appropriate measures are not taken.
Important information for trouble-free operation.
Intended use
Aquarius Universal, in the following termed "unit", and all other parts from the delivery scope may be used exclusively
as follows:
− For pumping clear water used for indoor and outdoor fountain pumps, table fountain pumps and statues.
− Aquarius Universal 80: Only operate in closed rooms.
− Operation under observance of the technical data.
The following restrictions apply to the unit:
− Do not use in swimming ponds.
− Never use the unit to convey fluids other than water.
− Never run the unit without water.
− Do not use for commercial or industrial purposes.
− Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
− Do not connect to the domestic water supply.
Important! The unit is equipped with a permanent magnet. The magnetic field may affect the function
of pacemakers.
Use other than that intended
This unit can be dangerous and cause harm to persons if not used in accordance with these instructions. Any use not
in accordance with these instructions or modification(s) to the unit will void the limited warranty.
4
- English -
Submerged installation (A, B)
Attention! Risk of damage! Ensure that the unit does not take in air or runs dry.
Align the intake of the suction unit (A). Lateral intake: Allows maximum flow, deposits from the bottom are not taken in.
Bottom intake: During operation, intake is possible up to a water level of 0.2 in. (5 mm). Only operate the unit with the
filter housing. Cut the stepped hose adapter to suit the hose diameter and screw onto the return (B1). Place the unit
horizontally with its feet downward (B2).
Dry installation (A, C)
Attention! Risk of damage! Ensure that the unit does not take in air or runs dry. Do not connect the unit to a
water line.
Align the intake of the suction unit upward (A). Operate the unit without filter housing. Cut both stepped hose adapters
to suit the hose diameters, then screw each adapter on the intake and return (C1) Place the unit horizontally with its
feet downward (C2). To prevent air from being taken in, ensure that unit and supply hose are always below the water
level (C2).
Start-up
Attention! The pump must never run dry.
Possible consequence: The pump will be destroyed.
Protective measure: Check the water level at regular intervals. Always place the unit below water level.
Set the flow at the controller (D).
This is how to connect the power supply:
Switching on: Connect power plug to the socket. The unit switches on immediately when the power connection is
established.
Switching off: Disconnect the power plug.
Attention! The installed temperature monitor automatically turns the pump off, if it is overloaded. The pump
automatically switches on again once the motor has cooled down. Risk of accident!
Install the unit so that it is not exposed to direct sun radiation (max. 104 ºF - 40 ºC).
Maintenance and cleaning
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
− Prior to reaching into the water, disconnect the power supply to all units used in the water.
− Disconnect the power plug prior to carrying out work on the unit.
Cleaning the unit
Dismantle and clean the unit (E).
If necessary, clean the unit with clear water using a soft brush.
− In the event of stubborn furring (calcium deposits), a common household cleaner free from vinegar and chlorine can
be used. Subsequently, clean the pump thoroughly using clear water.
− Never use aggressive cleaning agents or chemical solutions. These could attack the housing surface or impair the
function.
5
Loading...