Oakworks Single Carbon Fiber Arm Board User Manual

USER MANUAL - SINGLE CARBON FIBER ARM BOARD
MODELS
Standard Arm Board:
3395-01: with 1” pad (2.5cm) 3395-05: with 2” pad (5cm) 3395-06: with 4” pad (10cm) 3395-07: with 3” pad (7.5cm) 3395-04: with 2” & 4” pads (5cm & 10cm)
Wide Arm Board:
3395-03: with 1” pad (2.5cm)
Product & Serial # Locations
PART IDENTIFICATION
Standard Arm Board Pads:
4405-06: 1” pad (2.5cm) 4407-06: 2” pad (5cm) 4408-06: 4” pad (10cm)
Wide Arm Board Pad:
4406-06: 1” pad, wide (2.5cm)
Support Section
Base Section
USE
This radiolucent device can be used with any at support surface where ionizing radiation (x-ray) is utilized for imaging. This arm board can be used for imaging in any environment including private practice, hospital & surgery. It can be used to support arms and feet. Note this product is an
imaging platform & is not a surgical platform
DIRECTIONS
Unfold the Arm Board and slide the Base Section under the patient and the table top. Position the patient and the Support Section to suit the needs of the procedure. The weight of the patient will hold the Arm Board in place.
Rotate the Support Section to the desired position. This section rotates up to 180º.
CAUTION
DO NOT exceed 30 lbs. (13.6 kg) of load on the Support Section. Injury can occur.
Prone Position at 135
To remove the Arm Board, ask the patient to move their limb off the Support Section and lift their body slightly. This will allow you to pull out
the Base Section of the Arm Board. Fold the Base and Support Sections for storage.
º
Supine Position at 180
º
CLEANING & DISINFECTION
Use a 10% sodium hypochlorite (bleach) solution or Recommended Disinfectants on all surfaces. Remove the pad to clean all sides. Follow the direc- tions on the disinfectant and wipe off excess.
Recommended Disinfectants (Approved US Products): Protex, MadaCide, Accell TB, Virox® (Customer to suggest disinfectants available in other
countries. Oakworks must approve.)
Note: Damage caused by unapproved substances will not be covered under the warranty.
SPECIFICATIONS
Dimensions (Width x Length) Standard Arm Board
Dimensions (Width x Length) Wide Arm Board
Maximum Weight Rating 30 lbs. (13.6 kg)
Radiolucency
Base Section: 7.5” x 24” (19cm x 61cm) Support Section: 6” x 23” (15cm x 58cm)
Base Section: 7.5” x 24” (19cm x 61cm) Support Section: 7.5” x 24” (19cm x 61cm)
Arm Board: Maximum of 1.30mm AL @ 100 kVp. HVL of 3.6mm 1” Pad (2.5cm): Maximum of .42mm AL @ 100 kVp. HVL of 3.6mm 2” Pad (5cm): Maximum of .57mm AL @ 100 kVp. HVL of 3.6mm 4” Pad (10cm): Maximum of .79mm AL @ 100 kVp. HVL of 3.6mm
Phone: 717-235-6807 www.oakworksmed.com
923 East Wellspring Rd. New Freedom, PA 17349
Part No. MMINMD0003-EN Rev. D
Loading...