Oakworks Portal Light User Manual
R
PORTAL LIGHT
®
by OAKWORKS
OWNER’S MANUAL
Phone: 717.235.6807 www.oakworks.com
ASSEMBL ED BY
HAND IN THE
USA
PORTAL LIGHT by OAKWORKS
®
CamLocks
Face rest
knobs
Arm rest
Arm rest
buckle & strap
Personal item
storage shelf
Horizontal bar
& locking arm
Face rest
Chest Pad
Seat
Knee
2) Insert bar into arm
Pads
OWNER’S MANUAL
SETTING UP YOUR MASSAGE CHAIR
1. Holding folded chair as shown, move the horizontal bar down
& insert the bar into locking arm. (photo 1 & 2)
2. Wrap Velcro® around inserted bar to insure locking. (photo 3)
3. Loosen face rest knobs and insert face rest platform arms into the
tubes on the back of the chest pad plate. (see photos 4 & 5)
HELPING YOUR CLIENT ONTO THE CHAIR
1. Have your client stand on the side of the chair and grasp the
chair frame just above the chest pad for support.
2. Have the client straddle the seat and place their far knee on the
knee pad.
3. Your client can then gradually begin to sit down. Once seated,
the client can put their other knee on the knee pad.
4. You can then make the adjustments to the face and arm rests
for proper client comfort and positioning.
1) Move horizontal
bar down
4) Face rest knob 5) Vertical adjustments
6) CamLock™ 7) Face rest positioning
3) Wrap Velcro® to secure
FACE REST ADJUSTMENTS FOR OPTIMAL CLIENT COMFORT
1. General Adjustment Information
A. Oakworks QuickLock™ face rest has virtually unlimited
positioning options. Vertical adjustment is achieved by
loosening the knobs, raising or lowering the face rest & then
tightening the knobs (photo 4 & 5). Angle adjustments are
achieved by unlocking the CamLocks & moving the face
rest. (figure 6 & 7)
B. The locking cams on the face rest can be easily reversed
to the other side of the chair if desired. Loosen the knobs,
remove the face rest, reverse the rods & re-insert into the
tubes. Tighten the knobs. (photo 4 & 5)
2. Adjustment for optimal client comfort
A. Release the CamLocks and knobs on the face rest (photo 4 & 6)
B. Have your client lean forward into the chest pad, letting
the chair support their weight.
C. Ask your client to hold onto the face rest and to pull the
face rest toward them until their forehead rests comfortably
on the pad.
D. Lock the CamLocks and tighten the knobs securely.
Do not over tighten the knobs - too much force may
cause stripping.
page 1
Loading...