Oakworks Paper Roll Holder for Treatment Tables User Manual

OAKWORKS® PowerLine & Seychelle

R

PAPER ROLL HOLDER INSTALLATION

Items required: 7/32” Dia. standard drill bit
Hand drill
Masking tape
Ruler
5/32” or 4mm Hex Key Wrench

2”

Step 1

Use masking tape to mark 2”
drilling depth.

Step 2

After table is set-up, select
position for first bracket to
be installed on the outside of
table leg on foot end of table.

Part #61624 – Oakworks Paper Roll Holder Kit

screws (2)

paper roll holder
bracket (2)

wooden dowel (1)

Step 3

Slide bracket along bottom
edge of table side frame until
it meets with the existing bolt
head. Ensure the dowel rod
seat on the bracket is facing
inwards.

Step 4

Holding the bracket firmly,
drill the bracket mounting
hole until the masking tape
reaches the bracket.

Step 5

Using the supplied screw & your hex
key wrench, secure the paper roll holder
bracket into place. Repeat steps 3 thru 5 on
the other side of table.

Step 6

Locate the wooden dowel & feed it thru
your paper roll. Place one end of the
wooden dowel in the hole located in the
paper roll holder bracket.

Toll Free: 800.558.8850 Phone: [phone] www.oakworks.com

Step 7

To secure the wooden dowel on the
other side, pull out the paper roll
holder bracket slightly & insert the
wooden dowel into the hole.

Part no.MMINML0013 rev. O.18.10