Oakworks Nova with ABC System Table Set Up and Care User Manual

OAKWORKS

®

TABLE SET UP & CARE

RECOMMENDED USE &

Nova with ABC System

POSITIONING TECHNIQUES

*patent pending

The ABC System allows you to customize the table to your client’s needs.

The cushion is adjusted to a comfortable
level allowing great support with less
pressure.

The adjustable cushion also offers a
great head support for both men &
women.

This position is very comfortable for
short periods of time and creates a
great stretch.

Toll Free: 800.558.8850 • Phone: [phone] • www.oakworks.com

TABLE SET UP

TO SET-UP THE TABLE:

Place the folded table sitting on
the rubber bumpers. With the
heel of your hand, bump the
UniLock™ tab between the face
rest outlets and the table will
open. Open the table up until
the legs are fully extended.

UniLock™

When the table is fully opened, use your foot as a
brace on one of the leg extensions. Using the handle, tilt
the table upright until all four feet are on the floor.
Lift one end of the table, press down on the middle and
tension the cables a little.

FOOT PUMP & HAND VALVE PLACEMENT:

Place the foot pump on the floor
below the table but within easy
reach of your foot. Run the tube
to the hand control through the
table handle to insure it is easy
to reach.

Check for and
remove any kinks
in the tubing system.

TO CHANGE THE TABLE HEIGHT:

When the table is set up, the
height should be adjusted to
the proper working height
for the therapist. Once this
is determined, adjust the legs
accordingly. Choose the hole
that represents the desired
height. After removing the
knob, put the bolt through
that hole. Replace and tighten
the knob by hand until snug.
Repeat on all other leg exten­sions, setting all extensions
at same height.

SHIATSU CABLES

1. With the table on its side,
remove the wing nut from
the bolt and remove long
brace, cable and washers
from the short brace.
Reassemble them without
the cable. Repeat on the
second wing nut.

CAUTION: Make sure the cables are slightly
tensioned before getting on the table.

page 1 www.oakworks.com

2. Turn the Unilock™ clasp to
the side.

3. Fold the legs against the
underside and lay the table
down flat on the floor.

CAUTION:

be installed as shown when using
table in normal height ranges.

Shiatsu Cables must