Oakworks Clinician Adjustable User Manual

INSTRUCTION MANUAL

Clinician Adjustable

ASSEMBLY & OPERATION INSTRUCTIONS

Flat Top

Lift Assist Back Rest Top

Lift Assist Salon Top

Shown with optional
Adjustable Side Arm Rests
and Universal Table Extender

www.oakworks.com · 717.235.6807

WARNINGS

TABLE ASSEMBLY INSTRUCTIONS

Parts Included:

1 - Table Top

ASSEMBLY INSTRUCTIONS

STEP 1

Place the table top upside down on the floor.

STEP 2

Each leg has a number by the top bolt that corresponds
with a number on the inside corners of the table top.
(Excluding non-cabinet versions of the Flat top and
Back Rest top tables. These legs are universal.) Pick
any leg and match the number. Place the top leg bolt
through the metal corner bracket (note – if you have an
adjustable leg section, it may be necessary to raise the
leg section to install the leg). Attach washer and nut
and tighten this bolt using the supplied wrench or your
own ½” socket wrench. Install one leg only.

1 - Wrench

8 - Washers

8 - Nylock
Nuts

4 - Main Legs
w/extensions

1 - Shelf

STEP 3

Place the shelf upside down on top of the table top.
Lift the corner of the shelf and place the bottom leg
bolt through the metal corner bracket of the shelf.
Place a flat washer and nut on the bolt and hand
tighten only.

STEP 4

Find the leg for the opposite corner
(match the number). Lift the shelf
and insert the 2 leg bolts through
the 2 metal corner brackets. Place
a flat washer and nut on each bolt
and turn the nut into position with
the wrench, but do not completely
tighten.

1

WARNINGS

STEP 5 Non-Cabinet models only

Repeat Step 4 for each of the remaining legs. Match
the number (Excluding non-cabinet versions of the Flat
top and Back Rest top tables. These legs are universal).
Hand tighten the bolts. After the last leg is installed
tighten all 8 bolts. Table assembly is now complete.
Turn table right-side up and proceed to directions for
use on the next page.

STEP 5 Cabinet models only

Locate the 3rd leg (match the number), correct
end panel (note that there is a large and small end
panel) and one set of doors (note – Top of doors
is marked with a “T” on the back side. The front
door is marked with an “F” and the rear door is
marked with an “R”.

Insert the 1st set of doors into the tracks and slide
towards the center of the table (make sure the “T”
is towards the fabric top). Keep light downward
pressure on the shelf to hold the doors and end
panel in place.

ASSEMBLY INSTRUCTIONS

Install end panel - Place correct end panel against
previously mounted leg (locate end of panel
between pins and leg flange).

Hold the leg and insert the 2 leg bolts through the 2
metal corner brackets. You may need to wiggle leg
and maybe tap lightly into the final position. Also
note that the small angle bracket mounted on the
leg fits on the plastic track. Place a flat washer and
nut on each bolt and turn the nut into position with
the wrench, but do not completely tighten. Repeat
this procedure for the last leg.

Tighten the top bolt on all 4 legs (bolt nearest the
fabric). Check that doors all slide easily. If they
slide easily, then tighten the 4 leg nuts located on
the shelf. If the doors do not slide easily then lift
up slightly on the shelf to produce a small gap
between shelf and edge of doors, then tighten the
leg shelf bolt. Table assembly is now complete.
Turn table right-side up and proceed to directions
for use on next page.

2