Manual Part Number
MMMNST0003
Revision date: 10.26.09
2nd Edition, October 2009
st
1
Edition, September 2003
English, Printed in USA
All rights are reserved. No part
of this document may be
photocopied, reproduced or
translated to another language
without prior written consent
of OAKWORKS
OAKWORKS
trademark of OAKWORKS®, Inc.
®
, Inc.
®
is a registered
Notice
The information contained in this
document is subject to change
without notice and should not
be construed as a commitment by
OAKWORKS
®
, Inc.
OAKWORKS®, Inc. assumes no
responsibility for any errors that
may appear in this document nor
does it make expressed or implied
warranty of any kind with regard
to this material, including, but not
limited to, the implied warranties
of merchantability and fitness for
a particular purpose.
OAKWORKS
®
, Inc. shall not be
liable for incidental or consequential damages in connection with or
arising out of the furnishing, performance, or use of this document
and the program material which it
describes.
TABLE OF CONTENTS
Symbol Identification .................................................................................. pg 1
Important Safety Instructions ........................................................................ pg 2
Contact Information ...................................................................... back cover
Lowered Arm Rest Shelf ............................................... pg 16
QuickLock™ Face Rest .............................................................pg 16
If the table will not change position .....................................pg 17
SYMBOL IDENTIFICATION
SYMBOL IDENTIFICATION
SYMBOL IDENTIFICATION
This symbol, when used in this manual and on product labels, represents
a caution warning. Be sure to read and comply with all precautions and
warnings.
This symbol, when used in this manual and on product labels, warns
against an electrical shock hazard. Be sure to observe and comply with all
warnings.
This symbol, when used in this manual or on product labels, indicates a
Protective Earth (Ground) Terminal.
This symbol when used in this manual or on product labels, warns that
during transport there should be no stacking of containers.
This symbol, when used in this manual or on product labels, indicates that
the product should be protected from moisture. The humidity specifications
for Transport & Storage are listed on page 31.
~
----
This symbol, when used in this manual or on product labels, indicates that
information is given regarding the recommended temperature limits
during transport and storing.
This symbol, when used in this manual or on product labels, indicates the
date of manufacture of the device.
This symbol, when used in this manual or on product labels, indicates
alternating current (AC).
This symbol, when used in this manual or on product labels, indicates
direct current (DC).
1
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical furnishing, basic precautions
should always be followed, including the following:
DANGER - To reduce the risk of electrical shock always unplug this
furnishing from the electrical outlet before cleaning.
WARNING - To reduce the risk of burns, fire, electric shock of injury to
persons:
1. Unplug from outlet before putting on or taking off parts.
2. Close supervision is necessary when this furnishing is used by, or near
children, invalids, or disabled persons.
3. Use this furnishing only for its intended use as described in these
instructions. Do not use attachments not recommended by the manufacturer.
4. Never operate this furnishing if it has a damaged cord or plug, if it is
not working properly, if it has been dropped or damaged, or dropped
into water. Contact Oakworks Customer Service before use.
5. Keep the cord away from heated surfaces.
6. Never drop or insert any object into any opening.
7. Do not use outdoors
8. Do not operate where aerosol (spray) products are being used or
where oxygen is being administered.
PRODUCT DESCRIPTION
9. To disconnect, remove plug from outlet.
10. Risk of electric shock - Connect this furnishing to a properly gounded
outlet only. See Grounding Instructions.
11. Weight Limit: (patient and accessories) 625 lbs.
12. Be certain that the table is completely lowered without any tilt being
present prior to discharging an ambulatory patient. The patient may
lose balance and fall.
13. Electrical Shock Hazard. The power supply/control module is located
below the base of the table. No user serviceable parts are inside. Refer servicing
to qualified personnel. Unplug wall connector prior to contact with any
cables connected to the power supply.
14. Keep fingers and hands away from underside of table top pinch points.
2
PRODUCT DESCRIPTION
Celesta Deluxe
- Model P5CA
PRODUCT DESCRIPTION
™
Head rest
Upholstered
Top (Celesta
Access End)
Auto-adjusting
arm rests
Hand
Control (1)
Leg Rest
Electronic
Lift Towers
(2)
Foot Control (1)
Table Specs* :
• Lifting Capacity: 625 lbs. (284 kg)
• Heights: 24”-35” (58 - 86 cm)
• Widths: 27”, 29”, 31” or 33”
(69, 74, 79, or 84 cm)
• Length: 72” (183 cm)
• Top: Electric Access Design Top
• Padding: Plush, 4” Aero•Cel™ or
6” Aero•Cel™
• Upholstery: TerraTouch™, UltraTouch™
chosen, natural material variations and padding density.
For electrical specs, see Specifications Chart
3
* Published weight and height may differ slightly due to options
PRODUCT DESCRIPTION
Celesta Lift
™
- Model P5CT
Upholstered
Top (Celesta
Access End)
Head rest
Manual
Back Rest
Control (2)
Manual Leg
Rest Control
(2)
Auto-adjusting
arm rests
Hand
Control (1)
(optional)
Leg Rest
Electronic
Lift Towers
(2)
Foot Control (1)
PRODUCT DESCRIPTION
Table Specs* :
• Lifting Capacity: 625 lbs. (284 kg)
• Heights: 24”-35” (58 - 86 cm)
• Widths: 29” or 31” (74 or 79 cm)
• Length: 72” (183 cm)
• Top: Manually Controlled
Access Design Top
• Padding: Plush, 4” Aero•Cel™ or
6” Aero•Cel™
• Upholstery: TerraTouch™, UltraTouch™
* Published weight and height may differ slightly due to options
chosen, natural material variations and padding density.
For electrical specs see Specifications Chart
4
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.