10” FIN FAN WITH ADAPTER
Model: FD10002A
IMPORTANT SAFETY INSTRUCTIONS
- Read these instructions
- Keep these instructions.
- Heed all warnings.
- Follow all instructions.
- Do not use this apparatus near water.
- Clean only with dry cloth.
- Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
- Do not install near any heat sources such as radiators, heat registers, stoves, amplifiers or
other apparatus that produce heat.
- Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles and the point where they exit from the apparatus.
- Only use attachments/accessories specified by the manufacturer.
- Unplug this apparatus during lightning storms or when unused for long periods of time.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as the power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain
or moisture, does not operate normally or has been dropped.
WARNING
CHOKING HAZARD - SMALL PARTS. This is not a toy. Not for children under 3 years old. Do not
use where small children can reach it. Do not operate the fan in the presence of explosive or
flammable fumes. There is a risk of explosion or leakage if batteries are incorrectly installed. Do
not mix old and new batteries. Do not mix alkaline, carbon-zinc or rechargeable batteries. Do
not dispose of batteries in fire because batteries may explode or leak.
O2COOL, LLC
Chicago, IL USA
312.951.6700
www.o2-cool.com
OPERATING INSTRUCTIONS
For best performance use fresh alkaline batteries. To install batteries, position fan face down,
slide out battery door on back, install batteries following (+/-) marks and replace door. You
may have to push down as you slide in. As a safety precaution, the fan includes 2 screws to lock
the battery compartment. Tighten screws using #1 Phillips screwdriver. Screws do not have to
be removed from the battery cover. To operate, slide switch located on side of fan. To operate
fan using AC power (120-240 VAC, 50-60 Hz), use supplied adapter only. Inserting adapter plug
into fan disconnects the installed batteries from the circuit. Remove batteries if fan will be
stored for two weeks.
TROUBLESHOOTING
If fan does not operate, verify batteries or supplied adapter are installed properly and nothing is
obstructing the fan blades.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
* Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
O2COOL, LLC
Chicago, IL USA
312.951.6700
www.o2-cool.com
Loading...