6.5” COMPONENT SPEAKER SYSTEM
Installation Instructions / Owner's Manual
NX650C
1
INTRODUCTION
Congratulations on your purchase of a NXS speaker system. Your selection of a
NXS Mobile Audio product indicates a true appreciation of fine musical reproduction.
Whether adding to an existing system or including the NXS component speakers in a
new system, you are certain to notice immediate performance benefits.
RECOMMENDATION
A speaker's performance is only as good as it's installation. Proper installation and
mounting location, will maximize the overall performance. We highly recommend
that you have your component speakers installed by an authorized NXS retailer.
However, if you decide to install them yourself, please review the following
installation guide. For up to date product and technical information, please visit our
website at www.nxsmobileaudio.com.
WARNING!
Exposure to high sound pressure levels can cause hearing loss or
damage. Listening to your system at loud levels while driving, will impair
your ability to hear traffic sounds and emergency vehicles. Use common
sense when listening to your system.
TWEETER INSTALLATION
To optimize the tweeter’s mounting location we provide three different mounting
configurations. Determine the best mounting type for your application and follow the
mounting illustrations below.
FLUSH MOUNT
Cutout for
tweeter 55mm
Twist clockwise to tighten
Twist counter-clockwise to loosen
Door Panel
SURFACE MOUNT
ANGLE MOUNT
2
Positive (+) Wire (Blue Color)
Connects to the Red (+) Terminal
Negative (-) Wire (Silver Color)
Connects to the Black (-) Terminal
The Tweeter’s Negative (-) Wire (Silver Color)
Connects to the Negative (-)
Tweeter Terminal
The tweeter’s positive (+) wire (blue color) connects to one of the three positive (+) tweeter
terminals (+3dB, 0dB or -3dB) depending on the desired output level for the tweeter.
In the following example we have connected the tweeter in the 0dB position.
To amplifier
Speed Clips
Mounting screws
Cutout for woofer
147mm
WOOFER INSTALLATION
In most cases the woofer can be mounted in the vehicle’s factory location without the
need to cut a hole in the door panel. However if a alternate location is selected, use
the enclosed speaker template to mark and cutout the holes required for the woofer
and screws. If needed the speed clips provided can be used to secure the mounting
screws.
CONNECTIONS
SPECIFICATIONS
Size 6.5” Component
Type 2-Way
Frequency Response 55Hz-22kHz
Crossover Slope 12dB
Tweeter Adjustment -3dB, 0dB, +3dB
Due to continuing product improvement, design and specifications subject to change without notice.
Tweeter Protection Yes
Peak Input Power 150W
Continuous Input Power 75W
Sensitivity 91dB
Impedance 4 ohm
www.nxsmobileaudio.com
NX650C Component Manual
Rev. 7.16.07
TAKE
CONTROL
TAKETAKE
CONTROLCONTROL
Loading...