5
• The installation in this manual is intended for qualified installers, service technicians or
persons with similar qualified background. Installation and electrical wiring must be done
by qualified professionals and in accordance with all appliance codes and standards,
including fire-rated construction.
• DO NOT attempt to install this appliance yourself. Injury could result from installing the
unit due to lack of appropriate electrical and technical background.
• Range hood may have very sharp edges; please wear protective gloves if it is necessary
to remove any parts for installing, cleaning or servicing.
• Activating any switch ON before completing installation may cause ignition or an
explosion.
• Due to the size and weight of this range hood, two people installation is recommended.
To reduce the risk of fire, electric shock, or injury to persons:
• For general ventilating use only. DO NOT use to exhaust hazardous or explosive
materials and vapors.
• The combustion air flow needed for safe operation of fuel-burning equipment may be
affected by this unit’s operation. Follow the heating equipment manufacturer’s guideline
and safety standards such as those published by the National Fire Protection
Association (NFPA), the American Society of Heating Refrigeration and Air Conditioning
Engineers(ASHRAE) and the local code authorities.
• Before servicing or cleaning unit, switch power OFF at service panel and lock service
panel to prevent power from being switched ON accidentally.
• Clean grease laden surfaces frequently. To reduce the risk of fire and to disperse air
properly, make sure to vent air outside. DO NOT vent exhaust into spaces between walls,
crawl spaces, ceiling, attics or garages.
• Ducted fan MUST always be vented to the outdoors.
• Use only metal ductwork and this unit MUST be grounded.
• Sufficient air is needed for proper combustion and exhausting of gases through the duct
to prevent back drafting.
• When cutting or drilling into wall or ceiling, be careful not to damage electrical wiring or
other hidden utilities.
• All electrical wiring must be properly installed, insulated and grounded.
• Old duct work should be cleaned or replaced if necessary to avoid the possibility of a
grease fire.
• Check all joints on duct work to insure proper connection and all joints should be
properly taped.
• Use this unit only in the manner intended by the manufacturer. If you have questions,
contact the vendor.
To reduce the risk of a stove top grease fire:
• Keep all fan, baffle, spaces, filter, grease tunnel, oil container and grease-laden surfaces
clean. Grease should not be allowed to accumulate on fan, baffle, spaces, filter, grease
tunnel and oil container.
Important Safety Notice
Read all instructions before installing and operating this appliance