NXP Austria CLEV6630B Integration Manual

1. Customer Evaluation Board CLRC663, CLEV6630B: Photo

Figure 1: Customer Evaluation Board CLRC663, CLEV6630B – side view.

Figure 2: Customer Evaluation Board CLRC663, CLEV6630B – bottom view.

Integration Manual: Customer Evaluation
Board CLRC663, CLEV6630B

Doc Rev 1.00 Approved — 2017.02.15

BL ID

2. Customer Evaluation Board CLRC663, CLEV6630B: Description

1. Operational desription

Customer Evaluation Board CLRC663, CLEV6630B, is an example of implementation of
ISO/IEC 14443A and ISO/IEC 14443B reader/writer and NFC reader/writer (P2P passive
initiator mode) on the same printed board. Middle size antenna, implemented on the same
pcb, permits reading/writing on distance up to 50 mm (RFID card or other NFC device). The
onboard USB connector permits direct connection and communication with personal
computer.

Power supply is via usb port or via SELV rated and limited power source ( 7-13.5V / 500mA).

On the Customer Evaluation Board CLRC663, CLEV6630B main parts are easily visible:

• the pcb antenna,

• the antenna matching components,

• the reader part: CLRC663 reader IC, LPC 1769 microcontroller IC, two crystall

oscillators and decopling capacitors, power supply ICs and EEPROM, USB serial
communication port and JTAG port.

The Customer Evaluation Board CLRC663, CLEV6630B uses USB serial communiation port
for communicating with personal computer and transfer data. JTAG port is for development
purposes (programming). Some test pins are added on pcb.

The Customer Evaluation Board CLRC663, CLEV6630B has following features:

• Supports ISO/IEC 14443A and ISO/IEC 14443B reader/writer up to 848 Kbps.

• Supports MIFARE 1K/4K encryption in reader/writer mode.

• Supports contactless RF communication according to the FeliCa protocol at 212 Kbps

and 424 Kbps.

• Supports P2P passive initiator mode in accordance with ISO/IEC 18092

• P2P supported for types: A (106 kbit/s), F (212, 424 kbit/s)

• ISO/IEC15693 reader (I-Code)

• ISO/IEC 18000 EPC-HF reader (I-Code ILT)

• EMVCo 2.3.1 digital & analog Compliance

• Serial communication via USB port with Personal computer

• Power supply via USB port or via external power adapter.

Disclaimer :

This module is intended only for development and evaluation purposes, and cannot be used
in a finished product.

Figure 3: Customer Evaluation Board CLRC663, CLEV6630B - Block diagram.
Figure 4: Customer Evaluation Board CLRC663, CLEV6630B: dimensions, pcb with

elements.