NVX BE-TSLAS-VCW104 Installation Manual

INSTALLATION GUIDE

BE-TSLAS-VCW104 B.O.O.S.T.

Series Bass Enclosure for Telsa Model S

Step 1

Remove upper trim panel using a soft
plastic panel removal tool to prepare
for the installation of the BE-TSLAS­VCW104.

Step 2

Place the BE-TSLAS-VCW104 enclosure
into the spot as shown. Make sure you
place the bottom of the box in first
ensuring the tab on the bottom is behind
the lip in the cubby.

Step 3

Using a marker outline the shape of the
bracket on the enclosure to the vehicles
metal panel. Also at this time mark the
hole in the center of the bracket which
will be drilled in step 4.

Step 4

Using a center punch mark the center
of the hole you made in step 3. Start by
using a smaller drill bit to create a pilot
hole. Next use a 7/16” drill bit to make
the final hole diameter.

Step 7

Using the supplied washer and ¼-20
10mm bolt start threading it into the
now installed Jack Nut. Make sure to
tighten the bolt till the Jack Nut has fully
collapsed. Do not over tighten due the
possibility of stripping the Jack Nut.

Step 5

Insert supplied Jack Nut into hole that
was created in step 4. Once inserted use
supplied dampening material to cover
the Jack Nut. Using a razor blade cut the
dampening material that is covering the
center hole of the Jack Nut.

Step 8

Once the enclosure has been mounted
reinstall the trim panel following step 1
in reverse. Now it’s time to enjoy you’re
new BE-TSLAS-VCW104!

Step 6

Connect speaker wires to the terminal
posts making sure the Positive and
Negative speaker wires are connected
to the correct terminal. Once connected
reinstall the BE-TSLAS-VCW104 into its
final mounting location.

We recommend the installation of
the NVX BE-TSLAS-VCW104 to be
performed by a professional that will
have the skills and tools to ensure
the job is done correctly. Please
follow the steps above to get the best
performance out of the BE-TSLAS­VCW104. Installing and mounting
NVX BE-TSLAS-VCW104 improperly
can present a serious safety hazard
in the event of a collision. If you have
any questions regarding installation
of this product or an amplifier in this
vehicle please feel free to contact
NVX directly for further guidance and
installation techniques.