NVX BE-LEX-IS0613-VCW104B.O.O.S.T Installation Manual

INSTALLATION GUIDE

BE -LEX -IS0613-VCW104 B.O.O.S.T

Series Bass Enclosure for Lexus IS 250 / 350 / F

Step 1

A) Remove the mounting screws from VCW

woofer. Keep mounting screws in a safe
place these will be used in the last step.

B) Remove woofer from B.O.O.S.T.

enclosure.

Step 2

A) Remove all contents from the trunk.

B) Remove the two cargo net hooks indicated

by the arrows in the picture.

C) Remove panel clip

Step 3

Pull back panel to access the mounting

bracket as seen in the picture.

Step 4

Using a step drill bit slowly open the hole

to 7/16”. Be sure to drill slowly to avoid
bending or twisting the factory mounting
bracket.

Step 7

From inside the enclosure, place the

supplied shorter 10mm bolt and washer
used to collapse the Jack Nut to secure the
first mounting point on the enclosure.
This may require pressure against the
enclosure to line up and thread the 10mm
bolt into the Jack Nut. (Tighten till snug)

Step 5

A) Insert supplied Jack Nut into the 7/16”

hole that was created in the last step.

B) With a pair of needle nose pliers grip the

end of the Jack Nut while slowly tightening
the supplied 10mm bolt to collapse the
jack nut into place. Remove the 10mm bolt
after the Jack Nut is fully collapsed.

Step 6

Run speaker wire from the amplifier

location to the B.O.O.S.T. enclosure and
attach the speaker wire to the terminal
positive and negative terminal. Position the
B.O.O.S.T enclosure into place and prepare
hardware for mounting the enclosure.

Step 8 Step 9

From inside the enclosure, place the

supplied longer 10mm bolt and washer
to mount the second and last mounting
location. This may require pressure against
the enclosure to line up and thread the
10mm bolt to into the floor mount.

(Tighten till snug)

With the enclosure mounted you will now

reinstall the woofer from Step 1. The
woofer will already be pre-wired for the
installation. Be sure to connect positive to
positive and negative to negative. Line up
the woofer with the pre-drilled holes in the
enclosure. Using the screws from Step 1
tighten the woofer down in a star pattern till
they are nice and snug. (Do not over tighten

and strip the pre-drilled holes)