nVent SLK15L34H24 User Manual
nVent CADDY Speed Link SLK with Hammer-On Flange Clip–SLK15L34H24
FT
F
H
W
T
a
• Complete system includes wire, locking device and pre-assembled nVent CADDY Hammer-On Flange Clip end fitting
• Installs with just a hammer
• Fits most beams
Part Number SLK15L34H24
Material Steel
Finish Electrogalvanized
Static Load Safety Factor 5:1
Complies With SMACNA HVAC-DCS
Wire Rope Diameter 1.5 mm
Wire Rope Length 9.9'
Flange Thickness (FT) 1/8" – 1/4"
Static Load (F) 44 lb
Height (H) 2.15"
Width (W) 3/4"
Thickness (T) 1/2"
Angle (a) 90° Max
Certifications cULus
Standard Packaging Quantity 20 pc
UPC 78285679996
EAN-13 8711893137484
Polypropylene
Zinc Alloy
UL, UR, cUL, cUR, cULus and cURus are registered certification marks of UL LLC.
WARNING
nVent products shall be installed and used only as indicated in nVent's product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from
your nVent customer service representative. Improper installation, misuse, misapplication or other failure to completely follow nVent 's instructions and warnings may cause product
malfunction, property damage, serious bodily injury and death and/or void your warranty.
© 2020nVentAll rights reserved
nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX and nVent LENTON are owned by nVent or its global affiliates.
All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.
Loading...