
MC/AC Cable Clip with Shot-Fire Bracket–MAC2SF
• Provides easy snap-in installation of up to two MC/AC cables
• Complete with shot-fire bracket and pre-assembled drive pin from DEWALT
®
• Quickly and easily attaches to concrete, steel or composite metal decking
• Integrated pin installs easily using powder-actuated or single-shot gas-actuated tools
• ICC-ES ESR-2024 evaluation report available for drive pin from DEWALT
Part Number MAC2SF
Material Steel
Spring Steel
Finish Electrogalvanized
nVent CADDY Armour
MC/AC Cable Size 14-2 to 10-3
Height (H) 2 3/8"
Width (W) 2 3/16"
A 1.3"
Standard Packaging Quantity 100 pc
UPC 78285686646
EAN-13 0782856866466
®
Uses Powers Fasteners, Inc. part number 50032.
Pre-assembled drive pin from Powers Fasteners, Inc. works with Powers® C4CZ, Simpson® GCN-MEPKT, SPIT® P1000, P200, P2201, P3500 / PA3500, P35s, P45, P60, P7201, Sniper;
Ramset® 721, Cobra, D45 / D60 / D60L, M70, SA270, T3SS, TS750P, TS60P, Viper; Hilti® DX35, DX350 / DX351 / DX36M, DX100 / DX200, DX460, DXA40, DXA41, DXE72 / DX400; Würth
Diva-1, BST-1, BST-2 or equivalent nailers.
DEWALT is a registered trademark of Black & Decker Corporation. HILTI is a registered trademark of Hilti Aktiengesellschaft. Powers is a registered trademark of Stanley Black &
Decker. Ramset is a registered trademark of Illinois Tool Works, Inc. Simpson is a registered trademark of Simpson Strong-Tie Company Inc. SPIT is a registered trademark of Societe
De Prospection & D’Inventions Techniques Spit. Würth is a registered trademark of Adolf Würth GmbH & Co. KG.
WARNING
nVent products shall be installed and used only as indicated in nVent's product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from
your nVent customer service representative. Improper installation, misuse, misapplication or other failure to completely follow nVent 's instructions and warnings may cause product
malfunction, property damage, serious bodily injury and death and/or void your warranty.
© 2020nVentAll rights reserved
nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX and nVent LENTON are owned by nVent or its global affiliates.
All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.
®