nVent 52812P User Manual

T-Grid Rivet to Hanger Assembly–52812P

• Supports boxes and conduit above acoustical T-Grid

• Allows attachment of conduit clips with thread impressions at required height

• No tools required for installation

Part Number 52812P

Material Spring Steel

Finish nVent CADDY Armour

EMT Conduit Size 3/4"

Length 4 1/4" – 7 1/4"

Standard Packaging Quantity 25 pc

UPC 78285660682

Additional support wire required per NEC® 300.11.
No load rating, for positioning only.
Comes with P-series with THD impression screw assembled to top hole location (adjustable).

NEC is a registered trademark of, and National Electrical Code (NEC) standard is a copyright of the National Fire Protection Association, Inc.



WARNING
nVent products shall be installed and used only as indicated in nVent's product instruction sheets and training materials. Instruction sheets are available at www.erico.com and from
your nVent customer service representative. Improper installation, misuse, misapplication or other failure to completely follow nVent 's instructions and warnings may cause product
malfunction, property damage, serious bodily injury and death and/or void your warranty.



© 2020nVentAll rights reserved
nVent, nVent CADDY, nVent ERICO, nVent ERIFLEX and nVent LENTON are owned by nVent or its global affiliates.
All other trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.