Nux B-5RC Owner`s Manual
WARNING
To reduce the risk of fire or electric shock, do not expose this appliance to rain
or moisture.
CAUTION
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica tions.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consu lt the dealer or an experienced radio/TV technician for help .
To maintain compliance with FCC’s RF Exposure guidelines, this equipment
should be installed and operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.
The lightn ing symbo l within a triangle means , “Electrical
caution!” It indicates the presence of information about operating
voltage and potential risks of electrical shock.
The exclamation point within a triangle means, “Caution!”
Please read the information next to all caution signs.
NUX B-5RC guitar wireless system with automatic setup, 2.4 GHz
interference-free broadcasting frequency, and 24-bit 44.1 kHz highquality audio transmitting. The signal latency is super low and less than
5ms. The operation range is 30 meters (90-feet). It's a super lightweight wireless, mini-compact design that fits all types* of electric
guitar, electric-acoustic guitar, bass guitar, and ukulele.
*Tested on 25 varieties of different instruments, body types, and brands.
The user-friendly matching system makes it easier to use, just turn ON
both wireless units and it will be paired within a couple of seconds. Each
wireless set has a unique pairing algorithm, it automatically detects
each other and configures their own IDs. The signal never interferes
with any other wireless including the WIFI* signal.
*Recommended: Please stay 2 meters (6 feet) away from the WIFI router
for the best performance.
NUX B-5RC comes with the power case to keep the wireless units
charged. When the power case is fully charged, it can re-charge the
wireless units' battery 2-3 times.
Power Case
B-5RC
Transmitter
Receiver
HowtoOperate
Matching a set of B-5RC is very easy as it is pre-paired from the factory.
Just turn on the transmitter and the receiver; they should detect each
other rapidly and automatically choose the best channel to establish a
stable connection.
-Push and hold the power button to turn on the transmitter and the
receiver.
-Before the connection is established, the LED indicator indicates the
battery level. Refer to the chart below for details.
Green – Battery 100%≥Battery≥75%
Yellow – Battery 75%＞Battery≥50%
Red – Battery 50%＞Battery≥25%
Red blinking for 10 times – Battery < 25%, and the unit will turn off
automatically to protect battery life.
(100%≥Battery≥75%)
(75%＞Battery≥50%)
HowtoOperate
Connect the transmitter to the output of your instrument, and connect
the receiver to the input of the next device in your signal flow or an
output device, i.e. amplifier, guitar pedal, or mixer.
Receiver
Transmitter
(50%＞Battery≥25%)
Battery (<25%)
A set of fully charged B-5RC can work for 4 hours. It requires 2.5 hours
to get the batteries fully charged. The LED indicator lights in red during
charging and the LED Indicator turns off when fully charged.
Once the connection is established, the LED indicator on both the
transmitter and the receiver lights in green. In case of a failed
connection, both LEDs flash in red, and you will need to establish the
connection manually. (Ref to Re-match ID & Pairing Manually for
details.)
Plug the wireless system back into the power case for storage or recharge by
the power case. Do remember to press the charging button on the power case
to activate the charging function. The status LEDs on the power case indicates
the battery level of the case. A fully charged power case can recharge the
wireless system 2-3 times.
Charging with the power case.
Loading...