Nux B-3 Plus Owner`s Manual
WARNING
To reduce the risk of fire or electric shock, do not expose this appliance to rain
or moisture.
CAUTION
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica tions.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consu lt the dealer or an experienced radio/TV technician for help .
To maintain compliance with FCC’s RF Exposure guidelines, this equipment
should be installed and operated with minimum distance of 20cm between
the radiator and your body. Use only the supplied antenna.
The lightn ing symbo l within a triangle means , “Electrical
caution!” It indicates the presence of information about operating
voltage and potential risks of electrical shock.
The exclamation point within a triangle means, “Caution!”
Please read the information next to all caution signs.
NUX B-3 PLUS 2.4GHz wireless microphone system is designed for those
who want to get rid of the cables and enjoy the wireless world without
complicated setup.
If the environment is full of RF transmitters, sometimes B-3 PLUS
will meet interference, please keep B-3 PLUS at least 3 meters
far from the Wi-Fi router.
NUX offers various of 2.4GHz wireless systems, you can use up to 6
systems simultaneously in one space.
Please avoid using other wireless systems together with NUX ones, or
there may be noise or interference issues.
Features
Easy to use 2.4GHz wireless microphone system
24bit/44.1kHz Hi-Resolution audio quality
Ultra-low latency<3.5ms
Auto pairing with channel selection
Long lasting built-in lithium battery(7 hours working time)
Transmitter
Female Port
Fastener Button
Battery & Channel Group Indicator
Power Switch Button
RF Status LED
Micro-USB Port
Receiver
Male Port
Battery & Channel Group Indicator
Power Switch Button
RF Status LED
Micro-USB Port
How to Operate
Transmitter and Receiver Pairing
B-3 PLUS has auto pairing and channel group selection. Please follow the
steps:
1.Turn on the Transmitter and Receiver units.
2.The Transmitter and Receiver will get paired automatically. (The device
will detect current RF environment and choose the suitable Channel
Group to operate while turn on.)
3.Connect the Transmitter to your dynamic microphone, and connect the
Receiver to your mixer or amplifier.
4.While you turn on the device, the battery indicator(s)willshow youthe
current battery status. Then the device will show you current group
selection.AndtheRFstatusindicator willshow"BLUE"whileworking,
iftheReceiverdoesnotgetthesignal, RF status indicator will show
“RED”.
MUTE mode:
While working, if you press the Transmitter’s power switch button, the
device will enter MUTE mode. The Transmitter and the Receiver’s RF
status indicators will show “RED”.
Receiver
Microphone
Mixer
Transmitter
Loading...