Nu-Vu AMP-12 User Manual
Food Service Systems
NU-VU®Roll-In Rack Proofer
®
Project
Item
Quantity
®
NU-VU®Food Service Systems
www.nu-vu.com
5600 13th Street
Menominee, MI 49858
1-800-338-9886 Toll Free
1-906-863-4401 Phone
1-906-863-5889 Fax
AMP-12
NU-VU®Roll-In Rack Proofer
NU-VU
®
AMP-12 Roll-In Rack Proofer
STANDARD FEATURES:
• Stainless steel construction
• Solid door
• Solid state controls
• AutoMist humidity system
• Magnetic door handle
OPTIONAL FEATURES:
• Stainless steel roll-in rack
(20-1115)
SIZE:
AMP-12 - 77-
1
/2” High, 32” Wide, 37-3/8” Deep
1969 mm High, 813 mm Wide, 949 mm Deep
NU-VU’s AMP-12 roll-in rack proofer features
heavy-duty stainless steel construction, with solid
doors. These units also feature the AutoMist
humidity system. While these units do not come
standard with a roll-in rack, they are available as
an accessory item.
CONSTRUCTION:
• Stainless steel construction
• Fully insulated
• Control panel accessible through front and
top of unit
• Heating elements accessible inside of cabinet
and through top
CONTROLS:
• Solid state controls
• Indicator light for thermostat
• Separate heat and humidity controls
LABORATORY CERTIFICATION AND APPROVAL
®
NU-VU®Food Service Systems
www.nu-vu.com
5600 13th Street
Menominee, MI 49858
1-800-338-9886 Toll Free
1-906-863-4401 Phone
1-906-863-5889 Fax
®
Food Service Systems
Approval / Stamp
AMP-12 Roll-In Rack Proofer
NU-VU
®
AMP-12 Roll-In Rack Proofer
SPECIFICATIONS:
ELECTRICAL:
SERVICE CONNECTIONS:
• Unit is shipped from factory to be hard wired on site.
Single phase uses three-wire system.
Three phase uses four-wire system.
• 208 or 240-Volt single or three phase is standard.
Please specify at time of order.
•A
1
/4” waterline is required. Awater softening system
should be used to minimize build-up.
INSTALLATION:
Allow four inches on each side and back of unit for
ventilation of oven.
DOOR SWING: Proofer - 30” (762 mm)
PACKING SIZE:
83” High, 40” Wide, 40” Deep
(2108 mm High, 1016 mm Wide, 1016 mm Deep)
SHIPPING WEIGHT:
600 Pounds (272 Kg), FOB Menominee, MI 49858
DIMENSIONS:
Height Width Depth
Exterior 77-
1
/2” 32” 37-3/8”
Interior
63-
1
/2” 24” 32”
Amp Draw 208/1 208/3 240/1 240/3
13 10 12 9
ELECTRICAL:
CAPACITY:
18”x26” 13”x18”
Sheet Pans Sheet Pans Spacing
Proofer 12 24 n/a
FRONT SIDE BACK
WATER INLET
ELECTRICAL
INLET
COOLING
FAN
77
1
/
2
”
73
1
/
4
”
11
3
/
4
”
5
3
/
4
”
5
/
8
”
7
”
37
3
/
8
”
34
1
/
8
”
32
”
RAMP
DRAIN
LISTINGS:
The AMP-12 has NSF and C-ETL-US listings.
Loading...