NuTone CFS-2 User Manual

1. Switch installs in single-gang outlet box.

2. Run 120vAC, 60 Hz house power supply to switch box and secure cable with box connector. Make wire connections to switch as shown in diagram.

CAUTION: Be sure switch is properly grounded and all wiring

complies with local codes.

3. Refer to installation Instructions provided with fan for wiring diagrams.

Refer to instructions packed with fan for Owner’s Information, including NuTone Warranty. If a fan instructions have been misplaced, write to Nutone’s Customer Service Department at the address below.

READ & SAVE THESE

INSTALLATION INSTRUCTIONS!

Two-Speed Switch

MODEL: CFS-2

For use with NuTone Whole-House Ventilation Fan

TO FAN

YELLOW AND RED FROM SWITCH

120vAC, 60 HZ HOUSE POWER

WIRING FOR TWO-SPEED SWITCH

YELLOW (LOW)

RED (HIGH)

BLACK

GREEN

GROUND

Product specifications subject to change without notice. 4820 Red Bank Road, Cincinnati, Ohio 45227

Printed in U.S.A., Rev. 11/02, Part No. 57169