NuTone 9427P, 9422P User Manual

MODELS 9422P & 9427P
INFRARED
BULB HEATERS

SPECIFICATION SHEET

Quick and efficient, these twin-bulb heaters provide
the selective temperature control you need.

FEATURES

White-white polymeric grille

•

Sturdy steel housing

•

Adjustable mounting brackets that span up to 24"

•

Housing can be adjusted vertically after ceiling is finished

•

Uses (2) 250W BR40-size infrared bulbs (not included)

•

Bulbs may be operated separately or in combination

•

using the following controls:

Model 59W/V, 60-Minute Time Control
Model 61W/V, 15-Minute Time Control
Model 62W/V, 60-Minute Time Control with 2 Toggle

Switches (Model 9427P only)
Model 63W/V, 60-Minute Time Control w/Toggle Switch
Model 66W/V, Heat/Fan/Light Control (Model 9427P only)
Model 68W/V, Two-Function Control

Suitable for use in insulated ceilings (Type I.C.)

•

MODEL 9427P BULB HEATER/FAN ONLY:

Plug-in, permanently lubricated motor

•
Quiet, polymeric blower wheel

•

Polymeric damper/duct connector with 1-5/8" long tapered

•

sleeve and no metallic clatter
Unit may function with bulbs and fan controlled together,

•

bulbs and fan controlled separately, or EACH bulb and fan
controlled separately

SPECIFICATIONS

MODEL VOLTS AMPS WATTS* SONES CFM DUCT

9422P 120 4.3 505** ---- ---- ----

9427P 120 4.5 545** 3.5 70 4" Round

* Total Connected Load

** BR40-size Infrared Bulbs. Use house wiring rated 60°C min.

HVI-2100 CERTIFIED RATINGS comply with new testing technologies
and procedures prescribed by the Home Ventilating Institute, for off­the-shelf products, as they are available to consumers. Product
performance is rated at 0.1 in. static pressure, based on tests
conducted in AMCA’s state-of-the-art test laboratory. Sones are a
measure of humanly-perceived loudness, based on laboratory
measurements.

NuTone, Inc., 4820 Red Bank Road, Cincinnati, OH 45227 (1-800-543-8687)

Product specifications subject to change without notice

TYPICAL SPECIFICATION

Bulb heater shall be NuTone Model 9422P (NuTone Model
9427P).

Heater shall have corrosion resistant steel housing and
adjustable mounting brackets.

Unit must use (2) 250W BR40-size infrared bulbs. Bulb
Heater to be U.L. Listed. Suitable for use in insulated ceilings
(Type I.C.)

MODEL 9427P BULB HEATER/FAN ONLY:
Motor assembly to be removable and permanently lubricated.

Non-metallic damper/duct connector to be included.

Heater and ventilator to operate separately (or in combination).

Air delivery shall be no less than 70 CFM and sound level no
greater than 3.5 Sones. All air and sound ratings shall be
certified by HVI.

Model
9422P

Model
9427P

REFERENCE QTY. REMARKS Project

Location

Architect

Engineer

Contractor

Submitted by Date

50G 99042989E