Nutek NTRQA User Manual
Register at caralarm.com
OPERATION GUIDE
AL-1775-3DB
RS-475-3D
al-1775-3db & rs-475-3d op guide.indd 1 8/3/16 7:41 AM
REMOTE START & SECURITY PERFECTED
AL-1775-3DB / RS-475-3D
OPERATION GUIDE
Temporary cover. Final cover is in a separate le.
1
Table Of Contents
Controller & Transmitter Overview..................................................................... 3
The 2-Way Controller .................................................................................... 3
The 1-Way Transmitter .................................................................................. 3
Controller & Transmitter Functions .................................................................... 3
Other Remote Start Features ............................................................................ 8
Low Vehicle Battery Alert ............................................................................... 8
Low Battery/Low Temp Automatic Starting .................................................... 8
Turbo Timer Mode ......................................................................................... 8
Pit-Stop Mode ................................................................................................ 8
XL Pit-Stop Mode .......................................................................................... 8
Manual Transmission Starting ....................................................................... 9
Security System Features ................................................................................. 9
Last Door Arming ........................................................................................... 9
Automatic Rearming ...................................................................................... 9
Pre-Warn Detection ....................................................................................... 9
When The System Triggers ......................................................................... 10
Using The Valet Button .................................................................................... 10
Emergency Override ................................................................................... 10
SecureCode ................................................................................................ 10
Valet Mode ....................................................................................................11
The Status Light ...............................................................................................11
Multi-Car Operation ......................................................................................... 12
Selecting CAR #1 or CAR #2 ...................................................................... 12
Controller Options............................................................................................ 12
In-Range Indicator ....................................................................................... 12
Selecting Melody, Soft Melody, & Mute modes ........................................... 12
Button Lock ................................................................................................. 12
Anti-Carjacking Protection ............................................................................... 14
Programming Controllers/Transmitters ............................................................ 15
Programming Features .................................................................................... 15
User Programmable Features ......................................................................... 16
Installer Programmable Features .................................................................... 19
2
THE 2-WAY CONTROLLER
Controller part number:
1511-03E (w/ 2 CR2025 batteries)
Call your dealer or visit www.caralarm.com to order
replacement transmitters.
Controller battery replacement:
Remove the small screw from the lower
back case, and separate the transmitter
halves. Replace the batteries and
reassemble the transmitter case.
Controller & Transmitter Overview
LOCK
button
UNLOCK
button
START
button
TRUNK
button
THE 1-WAY TRANSMITTER
Transmitter part number:
1412-03 (w/ 1 CR2032 batteries)
Call your dealer or visit www.caralarm.com to order
replacement transmitters.
Transmitter battery replacement:
Remove the small screw from the lower
back case, and separate the transmitter
halves. Replace the batteries and
reassemble the transmitter case.
LOCK
button
START
button
Controller & Transmitter Functions
LOCK / ARM: Press and release the LOCK button.
• THE SIREN WILL CHIRP & THE PARKING LIGHTS WILL
FLASH ONCE.
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL FLASH THE LOCK
BUTTON LED (TWICE FOR CAR 2) AND BEEP ONCE.
PROGRAM
button
UNLOCK
button
TRUNK
button
3
Controller & Transmitter Functions (cont’d)
UNLOCK / DISARM: Press and release the UNLOCK button.
• THE SIREN WILL CHIRP TWICE & THE PARKING LIGHTS
WILL FLASH TWICE.
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL FLASH THE UNLOCK
LED (TWICE FOR CAR 2) AND BEEP TWICE.
TRUNK RELEASE / CHANNEL 2: Press the TRUNK button for 3
seconds.
• THE SYSTEM WILL UNLOCK/DISARM AND THE TRUNK
WILL OPEN (IF EQUIPPED).
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL FLASH THE TRUNK LED
(TWICE FOR CAR 2) AND BEEP TWICE.
REMOTE START: Press and release the START button twice within 5
seconds (see user feature #8 to change).
• THE PARKING LIGHTS WILL FLASH ONCE AND THE STATUS
LIGHT WILL FLASH RAPIDLY.
• THE SYSTEM WILL PROCEED TO START THE ENGINE.
• UPON RECEIVING CONFIRMATION, THE CONTROLLER WILL
PLAY THE START MELODY AND FLASH THE START BUTTON
LED ONCE EVERY 1/2 SECOND (TWICE FOR CAR 2).
• ONCE THE ENGINE IS RUNNING, THE PARKING LIGHTS WILL
TURN ON AND THE STATUS LIGHT WILL FLASH SLOWLY.
• ALL 4 LED’S ON THE CONTROLLER WILL FLASH EVERY 5
x2
SECONDS INDICATING THE RUN TIME IS AT 100%. EACH LED
REPRESENTS 25% OF THE RUN TIME AND THEY WILL STOP
FLASHING ONE AT A TIME AS THE RUN TIME DECREASES.
• If the engine stalls, the system will make up to 3 more attempts.
• Each time you park, set the climate controls to give you the desired interior
temperature when you use the remote start.
• The engine will run for the preset run time (see user feature #1).
(continued on p. 5)
4
Controller & Transmitter Functions (cont’d)
• Run Time Extender: Press the START button one time during remote start to
restart the engine run timer. The timer will restart.
NOTE: This can only be used once per remote start cycle. The controller will also give you “run
time expiration warning” (2 beeps) 1 minute before the remote start cycle ends.
• If you decide not to drive your vehicle, you can turn off the remote start using the
same method to turn it on (Default = press START twice in 5 seconds).
NOTE: If user feature #8 is programmed for 1 press, the 1st press = Run Time Extender so an
additional press is required.
• Upon entering the vehicle during remote start mode, turn the ignition key to the
“ON/RUN” position (NOT START!!). When you press the brake pedal, the remote
start will turn off allowing the ignition key to take over.
CHANNEL 3: Press and hold the TRUNK & START buttons for 2
seconds.
• YOUR SYSTEM WILL ACTIVATE THE CH. 3 OUTPUT.
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL FLASH THE START &
TRUNK LED’S 3 TIMES.
CHANNEL 4: Press and hold the LOCK & TRUNK buttons for 2
seconds.
• YOUR SYSTEM WILL ACTIVATE THE CHANNEL 4
OUTPUT.
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL FLASH THE LOCK
& TRUNK LED’S 4 TIMES.
CHANNEL 5: Press and hold the UNLOCK & START buttons for 3
seconds
• YOUR SYSTEM WILL ACTIVATE THE CHANNEL 5
OUTPUT.
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL FLASH THE
UNLOCK & START LED’S 5 TIMES.
5
Controller & Transmitter Functions (cont’d)
PANIC: Press and hold the LOCK or UNLOCK button for 3 seconds.
• THE SIREN/HORN WILL SOUND, THE PARKING LIGHTS
OR
WILL FLASH, AND THE DOORS WILL LOCK OR UNLOCK
DEPENDING WHICH BUTTON IS PRESSED.
SILENT ARM / DISARM: Press and release the TRUNK button twice
in 5 seconds.
x2
• THE PARKING LIGHTS WILL FLASH, AND THE DOORS
WILL LOCK/ARM OR UNLOCK/DISARM DEPENDING ON
THE CURRENT SYSTEM STATUS.
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL FLASH THE LOCK OR
UNLOCK LED ONCE (TWICE FOR CAR 2)
SENSOR BYPASS: Press and release the TRUNK button within 5
seconds of locking/arming the alarm system.
2
• THE SYSTEM WILL GIVE ONE CHIRP, AFTER LOCKING,
TO INDICATE THE SENSOR IS BYPASSED.
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL ALSO CHIRP ONCE &
1
FLASH ALL 4 LED’S ONCE.
LOW VOLTAGE/TEMP AUTO START: Press and release UNLOCK,
LOCK, START within 5 seconds.
• THE SYSTEM WILL GIVE ONE CHIRP TO INDICATE
THE LOW VOLT/LOW TEMP(15° F ONLY) AUTOSTART
2
IS ACTIVATED. SEE PAGE 7 FOR MORE INFO.
• UPON RECEIVING CONFIRMATION, THE
1
3
CONTROLLER WILL CHIRP ONCE AND THE CLOCK
WILL READ “RS AUTO” EVERY 5 SECONDS.
• SEE PAGE 7 FOR FUNCTIONAL DETAILS.
REMOTE VALET: Press LOCK then UNLOCK then TRUNK + START
within 5 seconds.
1
6
3
• THE SYSTEM WILL ENTER VALET MODE.
2
SEE PAGE 10 FOR MORE INFO ON VALET MODES.
• UPON RECEIVING CONFIRMATION FROM YOUR
SYSTEM, THE CONTROLLER WILL PLAY A MELODY
TO EXIT VALET VIA REMOTE, REPEAT THESE STEPS
Controller & Transmitter Functions (cont’d)
VEHICLE TEMP REQUEST: Press and release “P” then START within
5 seconds.
• UPON RECEIVING CONFIRMATION, THE
CONTROLLER WILL PLAY A MELODY AND FLASH
THE LEDs TO INDICATE THE VEHICLE’S INTERIOR
TEMPERATURE.
2
• TEMP INDICATORS:
1 LED = LESS THAN 30°F
1
2 LEDs = 31-60°F
2 LEDs = 61-90°F
4 LEDs = OVER 90°F
LOCK/UNLOCK STATUS UPDATE REQUEST: Press and release “P”
then LOCK within 5 seconds.
2
• THE SYSTEM WILL SEND A FULL STATUS UPDATE
TO THE CONTROLLER IN CASE THE STATUS
CHANGED WHILE THE CONTROLLER WAS OUT OF
RANGE OR BY ANOTHER CONTROLLER.
• THE LOCK OR UNLOCK LED WILL FLASH.
• THERE IS NO AUDIBLE INDICATION .
1
AUXILIARY FUNCTIONS 1-4:
The actual operation of these functions will vary from car to car. They are designed to
operate extra vehicle functions like automatic sliding doors or motorized hatches. Aux
1-4 are virtual outputs only available on certain vehicles when this system is integrated
with the vehicle’s data network. Consult with your installer to nd out if any of these
functions are available for your vehicle. If so, conrm each operation with the controller
and write each function in the blank spaces provided below.
- Auxiliary 1 Function (___________________): To activate this function, press and
release the TRUNK and START buttons simultaneously).
- Auxiliary 2 Function (___________________): To activate this function, press and
release the LOCK and TRUNK buttons simultaneously).
- Auxiliary 3 Function (___________________): To activate this function, press and
release the UNLOCK and START buttons simultaneously).
- Auxiliary 4 Function (___________________): To activate this function, press and
release the UNLOCK and TRUNK buttons simultaneously).
7
Loading...