Nutek NTLC User Manual

USER MANUAL

TRANSMITTER CODE LEARNING The system has a four-transmitter memory capacity. Entering a fifth

transmitter will eliminate the first one entered. To replace lost transmitters, enter new transmitters twice to
eliminate all old codes.

To enter a transmitter into memory:

1.Enter vehicle and close door. Be sure interior lights are off.

2. Put system into Valet mode,

3. Within 5 seconds after entering Valet
Leave in the ACCY position.
system is in the transmitter code-learning mode.

4. Press the LOCK button of the new transmitter. The system will learn all channels of the new
transmitter. You should hear one long siren chirp that indicates the system learned the code.

5. Turn the ignition key OFF to exit the routine. Two long siren chirps will signal successful exit.
Remove the system from Valet mode using Transmitter, Valet switch, or Pulse code.

, turn ignition key to ACCY, OFF, ACCY, OFF, ACCY

You should hear one long siren chirp that indicates the