Nutek ATIA User Manual

Model S1BTXA

This transmitter is designed for use with your upgrade remote start
unit and is programmed by using the remote start's program switch in
combination with the transmitter button. Although this transmitter can
be programmed into any of the Audiovox remote start and or alarm,
remote start systems, it will offer limited use and should be used for
the remote start upgrade only.

To program this transmitter into your remote start upgrade unit:

1) Turn the ignition to the on position

2) Press and release the programming switch 3 times

3) Press and hold, for 3 seconds, the button of the transmitter you
wish to add until the parking light flashes indicating the transmitter
has been learned.

4) Repeat step 3 for each transmitter up to a total of 4.
Turn the ignition off to exit the program mode.

NOTE: Do not allow more than 15 seconds to lapse between steps
or the program mode will be automatically exited and you will have to
start over.

This device complies with FCC Rules Part 15 Operation is
subject to the following two conditions
(1) This device may not cause harmful interference and
(2) This device must accept any interference that may be
received, including interference that may cause undesired
operation.

NOTE:The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s
authority to operate the equipment

Transmitter Programming Guide

128-8606

1 of 2

ORDER FORM FOR TRANSMITTER S1BTXA

Attention: Transmitter Ordering Department
Important: To help us expedite your order, please print all of the

information legibly and mail this form and your payment according
to the instructions below.

1)Name:_____________________________________

2) Address:_________________________________________

3) City:________________State:________Zip Code:__________
4 T elephone Number:( )_____________________

5) Total Number Of Transmitters Required:_______
Cost Per Transmitter is: $65.00
Multiply By Number Of Transmitters X

6) Enter Total Amount Enclosed _______
(New York State Residents must include the appropriate sales tax)

7) Method of Payment:

Mastercard Visa Check or Money Order (do not send cash)

Credit Card Number:___________________________________
Credit Card Expiration Date: ____/___/____

8) Mail this form along with your payment to:

Audiovox Corporation 150 Marcus Blvd., Hauppauge N.Y.



© 2009 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-8606

Make Checks Payable To Audiovox Corporation

Transmitter Ordering Department

11788

Credit card purchasers can order additional or replacement
transmitters by phone. Simply dial 1 - 800 - 645 - 4994, and
follow the instructions from the operator interface

2

128-8606

2 of 2