Numatic TT 4045, TT 4055 Owner's Manual
Original instructions
Warning! Read instructions before using the machine
www.numatic.com
TT 4045
TT 4055
TT 4045
TT 4055
Owner Instructions
2
Index
Machine overview
Rating label / Personal Protective Equipment / Recycling
Safety Precautions / Specications
Page 2
Page 3
Page 4
Page 5 / 6
! !
Before continuing, please refer to Set Up Guide on Page 6/7
Machine Set Up
Tilting the Handle
Fitting the Top Tank
Fitting the Brush
Tipping the Brush Deck
Fitting the Floor-tool
Fitting the hose guide
Fill the Clean-water tank
Clean Water Level
Control of Cleaning substances (COSHH)
Clean Water Tap On / Off
Pre Cleaning
Pre Scrubbing
Lowering the oor-tool
Breakaway oor-tool feature
Setting the cleaning controls
Regular Maintenance
Tanks and Filters
Changing the Floor-tool Blades
Specications
Trouble shooting
Recommended spare parts
Schematic Diagram
Warranty
Declaration document
Company Addresses
Page 6
Page 6
Page 7
Page 7
Page 7
Page 8
Page 8
Page 9
Page 9
Page 9
Page 9
Page 10
Page 10
Page 10
Page 11
Page 12
Page 13
Page 14
Page 15
Page 15
Page 16
Page 18
Page 19
Page 20
3
Machine Overview
1
3
4
5
6
7
8
10
13
14 14
15
16
17
18
19
20
21
11
2
22
9
12
13
19
1 Operator Control Panel 12 On / Off Switch
2 Separator 13 Triggers
3 Top Tank (waste-water) 14 Clean-water Tank Fill Point / Filler Hose
4 Waste-water Emptying Hose 15 Floor-tool Vacuum Hose
5 Bottom Tank (clean-water) 16 Vacuum Hose
6 Deck Locking Pin 17 Clean-water Tank Emptying Hose & Fill Level
7 Brush Deck 18 Floor-tool Lifting Lever
8 Handle Position Lever 19 Floor-tool Retaining Knobs
9 Vacuum Switch 20 Semi Parabolic Floor-tool
10 Pump Switch 21 Clean Water Filter
11 Power Light 22 Brush
8
4
Rating Label
WEEE (Waste, Electrical and Electronic Equipment)
Scrubber dryer Accessories and packaging should be sorted for environmentally-friendly recycling.
Only for EU countries.
Do not dispose of scrubber-dryer into household waste.
According to the European Directive 2002/96/EC on waste electrical electronic equipment and its
incorporation into national law.
Scrubber-dryers that are no longer suitable for use must be separated, collected and sent for
recovery in an environmentally-friendly manner.
Safety Critical Component:
Mains lead:
H05VV-F x 1.5 mm2 x 3 core
About the Machine
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
Company Name & Address
Machine Description
Voltage Frequency
Power rating
Max Gradient
Weight (ready to use)
CE Mark
WEEE Logo
Ingress Protection Rating
Machine Year/Week Serial number
10
10
11
12
13
11
12
13
Machine Description
Noise Rating
Hand Arm Vibration
Ear Protection Safety Footwear Head Protection Safety Gloves
Dust/Allergens
Protection
Eye Protection Protective
Clothing
Hi-Vis Jacket
Caution
Wet Floor Sign
Note:
A risk assessment should be conducted to determine which PPE should be worn.
PPE (Personal protective equipment) that may be required for certain operations.
In the event of a breakdown contact your Numatic dealer or the
Numatic Technical help line +44 (0)1460 269268
5
As with all electrical equipment care and attention must be exercised at all times during its use, in addition
to ensuring that routine and preventative maintenance is carried out periodically in order to ensure its safe
operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard could render
this equipment unsafe and the manufacturer can accept no responsibility or liability in this respect.
When ordering spare parts always quote the Model Number / Serial Number specied on the Rating Plate.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
This machine is not suitable for picking-up hazardous dust.
Do not use on surfaces having a gradient exceeding that marked on the appliance.
The machine is not to be stored outdoors in wet conditions.
This machine is for indoor use only.
Read the instruction manual before using the appliance.
This product meets the requirements of IEC 60335-2-72
NOTES
This machine is also suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and
ofces for other than normal housekeeping purposes.
• Ensure only competent persons unpack/assemble the machine.
• Keep your machine clean.
• Keep your brushes in good condition.
• Replace any worn or damaged parts immediately.
• Regularly examine the power cord for damage, such as cracking or ageing. If damage is found,
replace the cord before further use.
• Only replace the power cord with the correct Numatic approved replacement parts.
• Ensure that the work area is clear of obstructions and / or people.
• Ensure that the working area is well illuminated.
• Pre-sweep the area to be cleaned.
• Use steam cleaners or pressure washers to clean the machine or use in the rain.
• Attempt machine maintenance or cleaning unless the power plug has been removed from the supply outlet.
• Allow any inexperienced repairs. Call the experts.
• Strain cable or try to unplug by pulling on cable.
• Leave the brush pad on the machine when not in use.
• Allow the machine to be used by inexperienced or unauthorised operators or without appropriate training.
• Use the machine without the solution tanks properly positioned on the machine, as shown in the instructions.
• Expect the machine to provide trouble-free, reliable operation unless maintained correctly.
• Lift or pull the machine by any of the operating triggers, use the main handle.
• Remove the handle from the machine except for service and repair.
• Use on surfaces having a gradient exceeding that marked on the machine.
Information for Scrubber Dryer
Component Interval Inspect for
Mains Lead DAILY Scufng, cracks, splits, conductors showing
Brushes DAILY Bristle damage, wear, drive collar wear
Squeegee Blade BEFORE EACH USE Wear, cracks, splits
Filters BEFORE EACH USE Clogging and debris retention
Tanks AFTER EACH USE Rinse dirty water tank after use
WARNING
ORIGINAL INSTRUCTIONS
READ MANUAL BEFORE USE
CAUTION
DO
DON’T
6
• Only use brushes provided with the appliance or those specied in the instruction manual.
• The use of other brushes may impair safety.
• A full range of brushes and accessories are available for this product.
• Only use brushes or pads which are suitable for the correct operation of the machine for the specic task
being performed.
• It is essential that this equipment is correctly assembled and operated in accordance with current safety
regulations.
• When using the equipment always ensure that all necessary precautions are taken to guarantee the safety of the
operator and any other persons who may be affected.
• Wear nonslip footwear when scrubbing. Use a respiratory mask in dusty environments.
• The machine, while charging, must be positioned so that the mains plug is easily accessible.
• When cleaning, servicing or maintaining the machine, replacing parts or converting to another function the power source
shall be switched off.
• Mains operated machines shall be disconnected by removing the power plug, and battery operated machines shall be
disconnected by switching off the isolating key.
• Machines left unattended shall be secured against unintentional movement.
• When detergents or other liquids are used, read the manufacturer’s instructions.
• Do not allow the supply cord to come into contact with the rotating brushes.
• Operators shall be adequately instructed as to the correct use of the machine.
WARNING
Machine Set Up
PLEASE READ BEFORE COMMENCING ANY OPERATION
AFTER THE REMOVAL OF ALL THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS
!!
Tilting the handle
Using the handle position lever
(Fig.1).
Move the handle into the upright
position (Fig.2).
Fit the top tank to the machine (Fig.3).
Fit both vacuum and oor-tool hose to
the separator (Fig.4).
Fitting top tank
1
2
3
4
Loading...