NTML GROUP MP60 User Manual

http://dat.to/mp60compliance

Caution:

Do not install this device if there is not least 10 meters
(30 feet) or more of wire between the electrical outlet and
the electrical service panel.
This device features an internal protection that will
disconnect the surge protective component but will
maintain power to the load - now unprotected. if
this situation is undesirable for the application, follow the
manufacturer's instructions for replacing the device.

(/hc/en-us)

SUBMIT A REQUEST (/HC/EN-US/REQUESTS/NEW)

Sign in (/hc/en-us/signin?return_to=https%3A%2F%2Fkb.datto.com%2Fhc%2Fen-us%2Farticles%2F360000523086&locale=1)

DATTO KNOWLEDGE BASE (/HC/EN-US) / DATTO NETWORKING (/HC/EN-US/CATEGORIES/115000077483-DATTO-NETWORKING)

/ DATTO MANAGED POWER (/HC/EN-US/SECTIONS/360000132986-DATTO-MANAGED-POWER)

DATTO NETWORKING

Search

MP60 FCC & IC Compliance

Michael Desorcie
Last Updated: Friday at 00:17

FOLLOW (/HC/EN-US/ARTICLES/360000523086-MP60-FCC-IC-COMPLIANCE/SUBSCRIPTION)

Topic

This article provides FCC and IC compliance information for the Datto MP60.

Environment

Datto MP60

Compliance Advisory

WARNING: Changes or modifications to this equipment not expressly approved by the part responsible for compliance
could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

Reorient or relocate the receiving antenna
Increase the separate between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help.

CAUTION: To maintain the compliance with the FCC’s RF exposure guideline, place the power strip unit at least 20cm
from nearby persons.

CAUTION: To maintain compliance with the Industry Canada’s RF exposure guideline, place the power strip unit at least
20cm from nearby persons.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Additional Resources

MP60 Features & Specifications (https://kb.datto.com/hc/en-us/articles/360000372086)
MP60 Quick Start Guide (https://kb.datto.com/hc/article_attachments/360001790423/MP60_Quick_Start_Guide.pdf)