NTI XTENDEX ST-C6HD-HDBT, XTENDEX, XTENDEX ST-C6HD(A)E-HDBT, XTENDEX ST-C6HD-DA-HDBT, XTENDEXST-C64K-300 Installation And Operation Manual
®
XTENDEX
Series
ST-C6HD-HDBT
ST-C6HD-DA-HDBT
ST-C6HD(A)E-HDBT
ST-C64K-300
HDMI, Digital/Stereo Audio, Ethernet, RS232
and IR Extender
Installation and Operation Manual
ST-C6HD-DA-HDBT Local Unit
(Left and Right End Views)
ST-C6HDE-HDBT Local Unit
(Left and Right End Views)
MAN150 Rev Date 12/8/2016
TRADEMARK
XTENDEX is a registered trademark of Network Technologies Inc in the U.S. and other countries.
COPYRIGHT
Copyright © 2008,2016 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored
in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise,
without the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202.
CHANGES
The material in this guide is for information only and is subject to change without notice. Network Technologies Inc reserves the
right to make changes in the product design without reservation and without notification to its users.
Note: CATx connection cable used between NTI XTENDEX Series Local and Remote or any XTENDEX Series products
should not be run underground, outdoors or between buildings.
WARNING: Outdoor or underground runs of CATx cable could be dangerous and will void the warranty.
i
TABLE OF CONTENTS
Introduction......................................................................................................................................................................1
Materials..........................................................................................................................................................................2
Connectors and LEDs.....................................................................................................................................................4
Limitations .......................................................................................................................................................................6
Preparation for Installation ..............................................................................................................................................6
Installation .......................................................................................................................................................................7
Installing The Remote Unit ..........................................................................................................................................7
Installing The Local Unit ..............................................................................................................................................8
Connect the CATx Cables...........................................................................................................................................8
Plug-in and Boot Up...................................................................................................................................................10
Infrared Control .............................................................................................................................................................11
100BaseT + RS232 Support.........................................................................................................................................12
Technical Specifications................................................................................................................................................13
Interconnection Cable Wiring Method...........................................................................................................................14
Troubleshooting.............................................................................................................................................................15
Warranty Information.....................................................................................................................................................15
TABLE OF FIGURES
Figure 1- Connect the extended components to the Remote Unit.....................................................................................................7
Figure 2- Installation with DVI-only monitor .......................................................................................................................................7
Figure 3- Connect the XTENDEX Local Unit to the source................................................................................................................8
Figure 4- Connect CATx cable...........................................................................................................................................................8
Figure 5- Connect the AC adapter to either the Remote Unit or the Local Unit ...............................................................................10
Figure 6- Connect IR Emitter and Receiver.....................................................................................................................................11
Figure 7- Connections for Ethernet and RS232 Support..................................................................................................................12
Figure 8- View looking into RJ45 female..........................................................................................................................................14
ii
NTI XTENDEX 600 Foot HDMI and IR Extender
INTRODUCTION
The XTENDEX Series ST-C6HD-HDBT HDMI HDBase-T Extender transmits uncompressed digital HDMI signal, IR, and optional
SPDIF digital audio up to 600 feet over a single CAT6a/7 23AWG cable (or up to 450 feet with solid CAT5e/6) using HDBase-T
technology. Each video extender consists of a local unit that connects to an HDMI source and IR emitter; and a remote unit that
connects to an HDMI display, IR receiver, and optional SPDIF speakers.
The XTENDEX Series ST-C64K-300 4K HDMI Extender transmits uncompressed digital HDMI signal, and IR up to 300 feet over a
single CATx solid wire cable. Each video extender consists of a local unit that connects to an HDMI source and IR emitter; and a
remote unit that connects to an HDMI display and IR receiver.
The XTENDEX Series Extender is extremely simple to install and has been thoroughly tested to insure reliable performance.
Through the use of CAT5e/6/6a/7 (CATx) cable it is possible to economically increase the flexibility of an entertainme nt system.
Here are some of the features and ways this can benefit you:
ST-C6HD-HDBT Features:
• Transmits an uncompressed high speed HDMI signal over one CATx cable.
• Supports HDTV resolutions to 1080p and video resolutions to 1920x1200.
o Extend 1080p up to 5,600 feet when combined with NTI's ST-FOHDMI-LC HDMI Extender via Fiber Optic
Cable.
• HDMI features supported:
o 1920x1200 resolution
o x.v.Color, sYCC601 color, Adobe RGB Color and Adobe YCC601 color
o Dolby TrueHD, DTS-HD Master Audio, Dolby Digital, and DTS
o Bandwidth up to 154 MHz (3.76Gbps)
o Support for CEC (consumer electronic control) compatible devices.
o Lip Sync
• HDCP compliant.
• Supports the DDC2B protocol.
• High quality, rugged steel construction with durable powder coat finish.
• Only one power supply is necessary. (Power supply can be connected to either the local or remote unit.)
• Full Infrared Remote (IR) control of HDMI source from remote HDTV using existing source remote control.
Options:
Available with optional SPDIF Digital Audio support. (order ST-C6HD-DA-HDBT)
Available with optional SPDIF Digital Audio and Stereo Audio support (order ST-C6HDA-HDBT)
Available with Ethernet port for 100BaseT extension to support a Local or Wide Area Network (LAN/WAN) connection + an
RS232 port for serial devices such as Touch Screen monitors (order ST-C6HDE-HDBT).
Available with “12VDC 2A” power rating (order ST-C6HD-HDBT-12VNPS)- 2.1 x 5.5mm power jack, AC adapter sold separately
1
NTI XTENDEX 600 Foot HDMI and IR Extender
ST-C64K-300 Features:
• Transmits an uncompressed high speed HDMI signal over one CATx cable.
• Supports Ultra HD 4Kx2K resolutions to 3840x2160(30Hz) 2K resolutions to 2048x1080, HDTV resolutions to 1080p and
computer resolutions to 1920x1200.
• Supports embedded digital audio through HDMI compatible TV’s or audio receivers.
• HDMI features supported:
o HDMI 1.4
o x.v.Color, sYCC601 color, Adobe RGB Color and Adobe YCC601 color
o Dolby TrueHD, DTS-HD Master Audio, Dolby Digital, and DTS
o Bandwidth up to 340MHz (10.2Gbps)
o Support for CEC (consumer electronic control) compatible devices.
o Lip Sync
• HDCP compliant.
• Supports the DDC2B protocol.
• High quality, rugged steel construction with durable powder coat finish.
• Only one power supply is necessary. (Power supply can be connected to either the local or remote unit.)
• Full Infrared Remote (IR) control of HDMI source from remote HDTV using existing source remote control.
MATERIALS
Materials Included with ST-C6HD-HDBT/ST-C64K-300 kit:
9 NTI XTENDEX Local Unit
9 NTI XTENDEX Remote Unit
9 1-HD-3-MM 3 foot male-to-male HDMI video cable
9 1-RCA-3-MM 3 foot male-to-male RCA cable (ST-C6HD-DA-HDBT and ST-C6HDA(E)-HDBT models only)
9 1- SA-3-MM 3 foot male-to-male 3.5mm stereo audio cable (ST-C6HDA(E)-HDBT models only)
9 1-100VAC to 240VAC at 50 or 60Hz-24VDC/1.0A AC Adapter (NTI#PS4202) (NOT included with ST-C6HD-HDBT-12VNPS)
9 1- Power Cord- country specific (NOT included with ST-C6HD-HDBT-12VNPS)
9 3 Foot IR-EMITTER (IR-EMTR-3)
9 3 Foot IR-RECEIVER (IR-RCVR-3)
9 2.1x.5.5mm DC Plug with 36” Lead (ST-C6HD-HDBT-12VNPS only)
9 This manual
Additional Materials Included with ST-C6HDE-HDBT kit:
9 CT6182 DB9 Female-to-RJ45 Female adapter
9 CT6488 DB9 Male-to-RJ45 Female adapter
9 2-CB4352 5 foot RJ45-to-RJ45 CAT5 patch cable
Additional materials may be required but are not supplied:
¾ CAT5e solid UTP ; 6/6a solid UTP; CAT6a solid UTP 23AWG; /CAT7 solid STP 23AWG (CATx) twisted-pair cables
terminated with RJ45 connectors wired straight thru- pin 1 to pin 1, etc. (see page 14 for proper EIA/TIA 568 B wiring method)
¾ HDMI male-male cable to connect a HDMI source or display (Order NTI # HD-xx-MM where xx=3, 6, 9,14,20,30, 50 and 100
foot cable).
¾ DVI-D male to HDMI-A male single link cable to connect a DVI source or display (Order NTI # DVI-HD-xx-MM where xx=3, 6,
10, or 15 foot cable)
2
NTI XTENDEX 600 Foot HDMI and IR Extender
¾ RCA male-male cable to connect the SPDIF digital audio (when supported) to an audio output devic e (Order NTI # RCA-x-
MM – see website for available lengths)
Always use the shortest possible cable for best performance.
Contact your nearest NTI distributor or NTI directly for all of your KVM needs at 800-RGB-TECH (800-742-8324) in US & Canada
or 330-562-7070 (Worldwide) or at our website at http://www.networktechinc.com
and we will be happy to be of assistance.
3
Loading...