NTI ST-IPHD-L-2GOPOE, ST-IPHD-R-2GOPOE Installation And Operation Manual

X

XTENDE

®

Series

ST-IPHD-L/R-2GOPOE

HDMI Over Gigabit IP Extender with Power

over Ethernet (POE)

Installation and Operation Manual

MAN304 Rev Date 1/18/2018

Front and Rear View of ST-IPHD-R-2GOPOE

TRADEMARK

XTENDEX is a registered trademark of Network Technologies Inc in the U.S. and other countries.

COPYRIGHT

Copyright © 2018 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored in a
retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise,
without the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202.

CHANGES

The material in this guide is for information only and is subject to change without notice. Network Technologies Inc reserves the
right to make changes in the product design without reservation and without notification to its users.

TABLE OF CONTENTS

Introduction....................................................................................................................................................................... i

MATERIALS....................................................................................................................................................................1

Applications.....................................................................................................................................................................2

Connections- Point-to-Point.........................................................................................................................................4

Connections- Point-to-Many........................................................................................................................................4

Connections- Many-to-Many........................................................................................................................................5

Technical Specifications..................................................................................................................................................6

Warranty Information.......................................................................................................................................................7

INTRODUCTION

The XTENDEX® HDMI Over Gigabit IP Extender multicasts digital video and audio signals to one or mor e receivers up to 333 feet
away over a 1000BASE-T Gigabit Network connected with CAT5e/6/7 cable. Each HDMI Over Gigabit IP Extender consists of a
local unit that connects to an HDMI source, and a remote unit that connects to an HDMI display. The local and remote units can
be connected together for a Point-to-Point connection via CATx cable or a Point-to-Many connection via a net work switch. Support
for multiple transmitters (Many-to-Many connection) requires a managed network switch.

Features

 Supports HDTV resolutions to 1080p.
 Ideal solution for digital signage applications.
 Power over Ethernet (PoE) - power supply not required at the local or remote unit.
 Broadcast real-time HDMI video and audio signals to multiple display locati ons with a managed or unmanaged (also

known as non-managed) network switch. Network switch must support Jumbo Frames.

 Transmits an HDMI signal over one CAT5e/6/7 cable.
 Supports video wall installations from 1x2 to 16x16 screens.
 Plug-and-Play installation allows receivers to find the transmitter automatically on the same network. (Network

configuration may be required for Managed network switch.)

 Easily expandable. Add remote units as you add monitors.
 Built-in scaler - watch compatible sources at 1080p.
 Supports 2-way RS232 commands (control software on a PC, or other automated control system hardware such as

Control4 or Crestron) to control any devices attached to the matrix using RS232.

 Integrated mounting brackets for easy surface/wall mounting.
 Inexpensive CAT5e/6/7 cable replaces bulky video cables.
 Support for multiple transmitters requires a Managed network switch with VLAN/IGMP support. Standard LAN switches

can only support one transmitter.

 Each VLAN acts as a separate HDMI Over IP Channel on the network.
 One transmitter can connect up to 200 receivers using cascaded managed network switches.
 Cascade managed network switches up to 3 levels, allowing the farthest display to be located up to 1,000 feet away from

the source device. Each receiver can be located up to 333 feet from the managed switch.

 For a point-to-many connection, a standalone network with an unmanaged network switch, hub, or router can be used

instead of a managed network switch.
 It is not recommended to use any other network devices on this standalone network as it may cause a degradation

in performance.

 Use a PC to access the built-in HTTP Interface of the managed network switch to control what signal is being

watched at each location.

 Use a Telnet client to access any receiver on the VLAN or network.
 Customizable EDID table on local unit.
 HDCP compliant.
 Local and remote units must be in the same LAN. The units do not support WAN connections.

i