NTI ST-FOUSB4K-LC User Manual

1

ST-FOUSB4K-LC

DVI/HDMI USB KVM Extender

Over Optical Fiber

User’s Guide

2

 Front/Rear Panel and Connectors

Transmitter

Receiver

 System Installation

1. Attach RX [DVI Out] to monitor by DVI-to-DVI or DVI-to-HDMI cable.

2. Attach keyboard/mouse/Touch screen to the RX USB-A for remote

console.

3. Attach PC’s USB to the RX’s USB-B port if there is a local RX PC.

4. Attach TX’s [DVI In] to PC DVI/HDMI by a DVI-to-DVI/HDMI cable.

5. Use a USB B-to-A cable to attach TX’s USB-B to PC.

6. Attach keyboard/mouse to the TX’s USB-A if you need TX local console.

7. Use a Dual Core LC connector SM Fiber cable to directly connect [SFP+]

port of TX to RX.

8. Power ON TX and RX. The TX’s PC DVI/HDMI will be displayed on the

RX’s monitor. The RX’s monitor EDID will be available on the TX’s PC.

9. The USB keyboard/mouse/Touch at the remote console should be able

to control the TX’s PC.

Note: This product can support HDMI source and monitor by using
DVI-to-HDMI cable for HDMI resolution up to 3840 x 2160 @ 30Hz.