NON−POLAR ALUMINUM ELECTROLYTIC
NPR, NPA (Non−Polarized) SERIES
SUBMINIATURE N0N−POLARIZED
(NPR: Radial Leads, NPA: Axial Leads)
The NPR and NPA Series subminiature aluminum electrolytic
capacitors are especially designed for use in circuits whose polarity is reversed or unknown or in crossover networks which do
not require tough characteristic requirements.
RATINGS
Capacitance Range: 0.47μf to 1000μf
Tolerance: ±20%
Voltage Range: 16V to 100V
PERFORMANCE SPECIFICATIONS
Operating Temperature Range:
−40°C to +85°C (−40°F to +185°F)
Leakage Current: I ≤ 0.002CV + 3μA (measured after
5 minutes of applied voltage)
I = Leakage Current (μA)
C = Nominal Capacitance (μf)
V = Rated Voltage (V)
Capacitance Tolerance (M): ±20%
measured at 20°C (68°F), 120Hz
Dissipation Factor: measured at +20°C (+68°F),120H
Rated Voltage 16 25 50 63 100
0.1μf to 1000μf 0.16 0.12 0.08 0.06 0.06
Impedance Ratio at Low Temperature: 120H
Comparison Z WV 16 25 50 63 100
Z @ −25°C (−13°F)/
Z @ +20°C (+68°F)
Z @ −40°C (−40°F)/
Z @ +20°C (+68°F)
2 1.5 1.5 2 2
3 2 2 4 4
Z
Surge Voltage:
DC Rated Voltage 16 25 50 63 100
Surge Voltage 20 32 63 79 125
Z
MECHANICAL SPECIFICATIONS
Lead Solderability:
Meets the requirements of MIL−STD 202, Method 208
Marking:
Consists of series type, nominal capacitance, rated
voltage, temperature range, anode and/or cathode
identification, vendor identification.
Recommended Cleaning Solvents:
Methanol, isopropanol ethanol, isobutanol, petroleum
ether, propanol and/or commercial detergents. Halogenated hydrocarbon cleaning agents such as Freon
(MF, TF, or TC), trichloroethylene, trichloroethane, or
methylchloride are not recommended as they may
damage the capacitor.
CASE SIZES AND DIMENSIONS:
NPR SERIES
Insulating
Sleeve
L
L’ 5.0 Min
D’ Ø = D Ø + 0.5 Max L’ = L + 1.0 Max at D Ø ≤ 8.0 L’ = L + 2.0 Max at D Ø ≥ 10.0
NPA SERIES
d Ø
18.0 Min
d Ø
L
A ±0.5
Insulating
Sleeve
D Ø
D’ Ø
Load Life: 1000 ±12Hrs @ +85°C (+185°F),
at rated voltage
Leakage Current: Within values specified above
Dissipation Factor: Within ±150% of specified value
Capacitance Change Max: ±15% of initial value
Rated Voltage Capacitance Change Max
160V to 450V Within 30% of the initial value
Shelf Life: 1000 Hrs @ +85°C (+185°F),
no voltage applied
Leakage Current: Within values specified above
Dissipation Factor: Within ±150% of specified value
Capacitance Change Max: Within ±15% of initial value
2.3 Max
35.0 Min 35.0 MinL’
D’ Ø = D Ø + 0.5 Max L’ = L + 1.0 Max at D Ø ≤ 8.0 L’ = L + 2.0 Max at D Ø ≥ 10.0
ORDERING INFORMATION
NPR 47 M 50
Series
Capacitance
Tolerance
Voltage
D Ø
D’ Ø
7NTE Electronics, Inc. D Voice (973) 748−5089 D FAX (973) 748−6224 D http://www.nteinc.com
NON−POLAR ALUMINUM ELECTROLYTIC
NPR, NPA (Non−Polarized) SERIES
NPR Series (Radial Type) Dimensions: Diameter (D Ø) x Length (L): mm
Rated Voltage (WV) 16 25 50 63 100
Surge Voltage
Cap (μf)
10 5 x 11 5 x 11 8 x 11.5 8 x 11.5 10 x 12.5
22 6 x 11 6 x 11 10 x 12.5 10 x 12.5 10 x 20
33 6 x 11 8 x 11.5 10 x 16 10 x 16 13 x 20
47 8 x 11.5 10 x 12.5 10 x 20 10 x 20 13 x 25
100 10 x 12.5 10 x 16 13 x 25 13 x 25 16 x 25
220 10 x 20 13 x 25 16 x 25 16 x 30
330 13 x 20 13 x 25 16 x 30.5
470 13 x 25 16 x 25
1000 16 x 25 16 x 30.5
* These dimensions are for reference only, please consult the factory for actual size.
NPR Series (Radial Type) Mechanical Specifications: mm
Outside Diameter (D Ø) 5 6 8 10 13 16
Lead Spacing (A) 2 2.5 3.5 5 5 7.5
Lead Diameter (d Ø) 0.5 0.6 0.6 0.6 0.6 0.8
* These dimensions are for reference only, please consult the factory for actual size.
NPA Series (Axial Type) Dimensions: Diameter (D Ø) x Length (L): mm
Rated Voltage (WV) 16 25 50 63 100
Surge Voltage
Cap (μf)
10 6 x 15 6 x 19 8 x 19 10 x 21
22 6 x 15 6 x 19 10 x 21 10 x 21 10 x 25
33 6 x 19 8 x 19 10 x 21 10 x 25 13 x 30
47 8 x 19 8 x 19 10 x 25 10 x 25 13 x 30
100 10 x 21 10 x 25 13 x 30 13 x 30 16 x 30
220 10 x 25 13 x 30 16 x 30 16 x 30
330 10 x 30 13 x 30 16 x 41 16 x 41
470 13 x 30 16 x 30
1000 16 x 30
* These dimensions are for reference only, please consult the factory for actual size.
NPA Series (Axial Type) Mechanical Specifications: mm
Outside Diameter (D Ø) 6 8 10 13 16
Lead Diameter (d Ø) 0.6 0.6 0.6 0.8 0.8
* These dimensions are for reference only, please consult the factory for actual size.
(V)
0.47 5 x 11 5 x 11
1.0 5 x 11 5 x 11 5 x 11
2.2 5 x 11 5 x 11 6 x 11
3.3 5 x 11 6 x 11 8 x 11.5
4.7 5 x 11 6 x 11 6 x 11 8 x 11.5
(V)
0.47 6 x 15 6 x 15
1.0 6 x 15 6 x 15 6 x 15
2.2 6 x 15 6 x 15 6 x 15
3.3 6 x 15 6 x 15 6 x 19
4.7 6 x 15 6 x 15 8 x 19
8
NTE Electronics, Inc. D Voice (973) 748−5089 D FAX (973) 748−6224 D http://www.nteinc.com