
ALUMINUM ELECTROLYTIC 160V to 450V
NEVH, NEHH SERIES
SUBMINIATURE HIGH VOLTAGE
(NEVH: Radial Lead, NEHH: Axial Leads)
The NEVH and NEHH series subminiature aluminum electrolytic
capacitors are ideal for polarized capacitor applications requiring
small size, high capacitance, high voltage, low cost, and dependability over broad temperature ranges.
RATINGS
Capacitance Range: 1.0µf to 470µf
Tolerance: -10%, +75%
Voltage Range: 160V to 450V
PERFORMANCE SPECIFICATIONS
Operating Temperature Range:
• For 160V and 250V:
-40°C to +85°C (-40°F to +185°F)
• For 350V and 450V:
-25°C to +85°C (-13°F to +185°F)
Leakage Current: I ≤ 0.02CV + 100µA (measured after
3 minutes of applied voltage)
I = Leakage Current (µA)
C = Nominal Capacitance (µf)
V = Rated Voltage (V)
Capacitance Tolerance (M): at +20°C (+68°F), 120H
Capacitance Values through 4.7µf -10% to +75%
Capacitance Values above 4.7µf -10% to +50%
Dissipation Factor: at +20°C (+68°F),120H
Rated Voltage 160, 250, and 350 450
1.0µf to 470µf 0.20 0.25
Z
Impedance Ratio at Low Temperature: 120H
Comparison Z WV 160-250 350 450
Z @ -25°C (-13°F)/
Z @ +20°C (+68°F)
Z @ -40°C (-40°F)/
Z @ +20°C (+68°F)
2 2 2
4 - -
Surge Voltage:
DC Rated Voltage 160 250 350 450
Surge Voltage 200 300 400 500
Load Life: 1000 ±12Hrs @ +85°C (+185°F),
at rated voltage
Leakage Current: Within values specified above
Dissipation Factor: Within ±200% of specified value
Capacitance Change Max: See Table
Rated Voltage Capacitance Change Max
160V to 450V Within 20% of the initial value
Shelf Life: 1000 Hrs @ +85°C (+185°F),
no voltage applied
Leakage Current: Within ±200% of specified value
Dissipation Factor: Within ±150% of specified value
Capacitance Change Max: Within ±20% of initial value
Z
Z
MECHANICAL SPECIFICATIONS
Lead Solderability:
Meets the requirements of MIL-STD 202, Method 208
Marking:
Consists of series type, nominal capacitance, rated
voltage, temperature range, anode and/or cathode
identification, vendor identification.
Recommended Cleaning Solvents:
Methanol, isopropanol ethanol, isobutanol, petroleum
ether, propanol and/or commercial detergents. Halogenated hydrocarbon cleaning agents such as Freon
(MF, TF, or TC), trichloroethylene, trichloroethane, or
methylchloride are not recommended as they may
damage the capacitor.
CASE SIZE AND DIMENSIONS:
NEVH SERIES
Insulating
Sleeve
L
L’ 5.0 Min
D’ Ø = D Ø + 0.5 Max L’ = L + 1.0 Max at D Ø ≤ 8.0 L’ = L + 2.0 Max at D Ø ≥ 10.0
18.0 Min
d Ø
A ±0.5
D Ø
D’ Ø
NEHH SERIES (Insulating Bar = Negative)
2.3 Max
Insulating
Sleeve
D Ø
D’ Ø
L
d Ø
35.0 Min 35.0 MinL’
D’ Ø = D Ø + 0.5 Max L’ = L + 1.0 Max at D Ø ≤ 8.0 L’ = L + 2.0 Max at D Ø ≥ 10.0
ORDERING INFORMATION
NEVH 47 M 160
Series
Capacitance
Tolerance
Voltage
5NTE Electronics, Inc. D Voice (800) 631-1250 (973) 748-5089 D FAX (973) 748-6224 D http://www.nteinc.com

ALUMINUM ELECTROLYTIC 160V to 450V
NEVH, NEHH SERIES
NEVH Series (Radial Type) Dimensions: Diameter (D Ø) x Length (L): mm
WV
Cap (µf)
1.0 6.3 x 11 6.3 x 11 8 x 11.5 10 x 12.5
2.2 6.3 x 11 8 x 11.5 10 x 12.5 10 x 16
3.3 8 x 11.5 10 x 12.5 10 x 16 10 x 20
4.7 8 x 11.5 10 x 12.5 10 x 16 13 x 20
10 10 x 12.5 10 x 20 13 x 21 13 x 25
22 10 x 20 13 x 25 13 x 25 16 x 31.5
33 13 x 21 13 x 25 16 x 31.5 18 x 35.5
47 13 x 25 16 x 25 18 x 36 22 x 35
100 16 x 25 18 x 36 22 x 35 25 x 40
220 18 x 35
330 22 x 35
470 22 x 40
* These dimensions are for reference only, please consult the factory for actual size.
NEVH Series (Radial Type) Mechanical Specifications: mm
Outside Diameter (D Ø) 6.3 8 10 13 16 18 22 25
Lead Spacing (A) 2.5 3.5 5 5 7.5 7.5 10 12.5
Lead Diameter (d Ø) 0.5 0.6 0.6 0.6 0.8 0.8 0.8 1.0
* These dimensions are for reference only, please consult the factory for actual size.
160 250 350 450
NEHH Series (Axial Type) Dimensions: Diameter (D Ø) x Length (L): mm
WV
Cap (µf)
1.0 6.3 x 16 8 x 16 8 x 16 10 x 20
2.2 8 x 16 8 x 20 10 x 20 10 x 20
3.3 8 x 16 10 x 20 10 x 20 10 x 20
4.7 8 x 20 10 x 20 10 x 20 13 x 25
10 10 x 25 10 x 20 13 x 25 13 x 30
22 10 x 20 13 x 25 13 x 30 16 x 30
33 13 x 25 13 x 30 16 x 30 16 x 40
47 13 x 30 16 x 30 16 x 40 16 x 40
100 16 x 30 16 x 40 18 x 40 22 x 40
220 22 x 40
330 25 x 52
470 22 x 52
* These dimensions are for reference only, please consult the factory for actual size.
160 250 350 450
NEHH Series (Axial Type) Mechanical Specifications: mm
Outside Diameter (D Ø) 6.3 8 10 13 16 18 22 25
Lead Diameter (d Ø) 0.6 0.6 0.6 0.8 0.8 0.8 0.8 0.8
* These dimensions are for reference only, please consult the factory for actual size.
6
NTE Electronics, Inc. D Voice (800) 631-1250 (973) 748-5089 D FAX (973) 748-6224 D http://www.nteinc.com