NTE Electronics NEVH SERIES, NEHH SERIES Catalog Page

ALUMINUM ELECTROLYTIC 160V to 450V
NEVH, NEHH SERIES
SUBMINIATURE HIGH VOLTAGE (NEVH: Radial Lead, NEHH: Axial Leads)
The NEVH and NEHH series subminiature aluminum electrolytic capacitors are ideal for polarized capacitor applications requiring small size, high capacitance, high voltage, low cost, and depend­ability over broad temperature ranges.
RATINGS
Capacitance Range: 1.0µf to 470µf Tolerance: -10%, +75% Voltage Range: 160V to 450V
PERFORMANCE SPECIFICATIONS
Operating Temperature Range:
For 160V and 250V:
-40°C to +85°C (-40°F to +185°F)
For 350V and 450V:
-25°C to +85°C (-13°F to +185°F)
Leakage Current: I 0.02CV + 100µA (measured after
3 minutes of applied voltage)
I = Leakage Current (µA) C = Nominal Capacitance (µf) V = Rated Voltage (V)
Capacitance Tolerance (M): at +20°C (+68°F), 120H
Capacitance Values through 4.7µf -10% to +75% Capacitance Values above 4.7µf -10% to +50%
Dissipation Factor: at +20°C (+68°F),120H
Rated Voltage 160, 250, and 350 450
1.0µf to 470µf 0.20 0.25
Z
Impedance Ratio at Low Temperature: 120H
Comparison Z WV 160-250 350 450
Z @ -25°C (-13°F)/ Z @ +20°C (+68°F)
Z @ -40°C (-40°F)/ Z @ +20°C (+68°F)
2 2 2
4 - -
Surge Voltage:
DC Rated Voltage 160 250 350 450 Surge Voltage 200 300 400 500
Load Life: 1000 ±12Hrs @ +85°C (+185°F),
at rated voltage Leakage Current: Within values specified above
Dissipation Factor: Within ±200% of specified value Capacitance Change Max: See Table
Rated Voltage Capacitance Change Max
160V to 450V Within 20% of the initial value
Shelf Life: 1000 Hrs @ +85°C (+185°F),
no voltage applied Leakage Current: Within ±200% of specified value
Dissipation Factor: Within ±150% of specified value Capacitance Change Max: Within ±20% of initial value
Z
Z
MECHANICAL SPECIFICATIONS
Lead Solderability:
Meets the requirements of MIL-STD 202, Method 208
Marking:
Consists of series type, nominal capacitance, rated voltage, temperature range, anode and/or cathode identification, vendor identification.
Recommended Cleaning Solvents:
Methanol, isopropanol ethanol, isobutanol, petroleum ether, propanol and/or commercial detergents. Halo­genated hydrocarbon cleaning agents such as Freon (MF, TF, or TC), trichloroethylene, trichloroethane, or methylchloride are not recommended as they may damage the capacitor.
CASE SIZE AND DIMENSIONS:
NEVH SERIES
Insulating
Sleeve
L L’ 5.0 Min
D’ Ø = D Ø + 0.5 Max L’ = L + 1.0 Max at D Ø ≤ 8.0 L’ = L + 2.0 Max at D Ø ≥ 10.0
18.0 Min
d Ø
A ±0.5
D Ø D’ Ø
NEHH SERIES (Insulating Bar = Negative)
2.3 Max
Insulating Sleeve
D Ø D’ Ø
L
d Ø

35.0 Min 35.0 MinL’
D’ Ø = D Ø + 0.5 Max L’ = L + 1.0 Max at D Ø 8.0 L’ = L + 2.0 Max at D Ø 10.0
ORDERING INFORMATION
NEVH 47 M 160 Series Capacitance Tolerance Voltage
5NTE Electronics, Inc. D Voice (800) 631-1250 (973) 748-5089 D FAX (973) 748-6224 D http://www.nteinc.com
ALUMINUM ELECTROLYTIC 160V to 450V
NEVH, NEHH SERIES
NEVH Series (Radial Type) Dimensions: Diameter (D Ø) x Length (L): mm
WV
Cap (µf)
1.0 6.3 x 11 6.3 x 11 8 x 11.5 10 x 12.5
2.2 6.3 x 11 8 x 11.5 10 x 12.5 10 x 16
3.3 8 x 11.5 10 x 12.5 10 x 16 10 x 20
4.7 8 x 11.5 10 x 12.5 10 x 16 13 x 20 10 10 x 12.5 10 x 20 13 x 21 13 x 25 22 10 x 20 13 x 25 13 x 25 16 x 31.5 33 13 x 21 13 x 25 16 x 31.5 18 x 35.5 47 13 x 25 16 x 25 18 x 36 22 x 35
100 16 x 25 18 x 36 22 x 35 25 x 40 220 18 x 35 330 22 x 35 470 22 x 40
* These dimensions are for reference only, please consult the factory for actual size.
NEVH Series (Radial Type) Mechanical Specifications: mm
Outside Diameter (D Ø) 6.3 8 10 13 16 18 22 25 Lead Spacing (A) 2.5 3.5 5 5 7.5 7.5 10 12.5 Lead Diameter (d Ø) 0.5 0.6 0.6 0.6 0.8 0.8 0.8 1.0
* These dimensions are for reference only, please consult the factory for actual size.
160 250 350 450
NEHH Series (Axial Type) Dimensions: Diameter (D Ø) x Length (L): mm
WV
Cap (µf)
1.0 6.3 x 16 8 x 16 8 x 16 10 x 20
2.2 8 x 16 8 x 20 10 x 20 10 x 20
3.3 8 x 16 10 x 20 10 x 20 10 x 20
4.7 8 x 20 10 x 20 10 x 20 13 x 25 10 10 x 25 10 x 20 13 x 25 13 x 30 22 10 x 20 13 x 25 13 x 30 16 x 30 33 13 x 25 13 x 30 16 x 30 16 x 40 47 13 x 30 16 x 30 16 x 40 16 x 40
100 16 x 30 16 x 40 18 x 40 22 x 40 220 22 x 40 330 25 x 52 470 22 x 52
* These dimensions are for reference only, please consult the factory for actual size.
160 250 350 450
NEHH Series (Axial Type) Mechanical Specifications: mm
Outside Diameter (D Ø) 6.3 8 10 13 16 18 22 25 Lead Diameter (d Ø) 0.6 0.6 0.6 0.8 0.8 0.8 0.8 0.8
* These dimensions are for reference only, please consult the factory for actual size.
6
NTE Electronics, Inc. D Voice (800) 631-1250 (973) 748-5089 D FAX (973) 748-6224 D http://www.nteinc.com
Loading...