NSC LM337LMX, LM337LZ Datasheet
LM337L
3-Terminal Adjustable Regulator
General Description
The LM337L is an adjustable 3-terminal negative voltage
regulator capable of supplying 100 mA over a 1.2V to 37V
output range. It is exceptionally easy to use and requires
only two external resistors to set the output voltage. Furthermore, both line and load regulation are better than standard
fixed regulators.Also,the LM337L is packaged in a standard
TO-92 transistor package which is easy to use.
In addition to higher performance than fixed regulators, the
LM337L offers full overload protection. Included on the chip
are current limit, thermal overload protection and safe area
protection.All overload protection circuitry remains fully functional even if the adjustment terminal is disconnected.
Normally, only a single 1 µF solid tantalum output capacitor
is needed unless the device is situated more than 6 inches
from the input filter capacitors, in which case an input bypass
is needed. A larger output capacitor can be added to improve
transient response. The adjustment terminal can be bypassed to achieve very high ripple rejection ratios which are
difficult to achieve with standard 3-terminal regulators.
Besides replacing fixed regulators, the LM337L is useful in a
wide variety of other applications. Since the regulator is
“floating” and sees only the input-to-output differential voltage, supplies of several hundred volts can be regulated as
long as the maximum input-to-output differential is not exceeded.
Also, it makes an especially simple adjustable switching
regulator,a programmable output regulator,or by connecting
a fixed resistor between the adjustment and output, the
LM337L can be used as a precision current regulator. Supplies with electronic shutdown can be achieved by clamping
the adjustment terminal to ground which programs the output to 1.2V where most loads draw little current.
The LM337L is available in a standard TO-92 transistor
package and a SO-8 surface mount package. The LM337L is
rated for operation over a −25˚C to +125˚C range.
For applications requiring greater output current in excess of
0.5A and 1.5A, see LM137 series data sheets. For the positive complement, see series LM117 and LM317L data
sheets.
Features
n Adjustable output down to 1.2V
n Guaranteed 100 mA output current
n Line regulation typically 0.01%/V
n Load regulation typically 0.1
%
n Current limit constant with temperature
n Eliminates the need to stock many voltages
n Standard 3-lead transistor package
n 80 dB ripple rejection
n Output is short circuit protected
Connection Diagram
DS009134-1
Bottom View
DS009134-2
Top View
Order Number LM337LM or LM337LZ
See NS Package Number M08A or Z03A
May 1998
LM337L 3-Terminal Adjustable Regulator
© 1999 National Semiconductor Corporation DS009134 www.national.com
Absolute Maximum Ratings (Note 1)
If Military/Aerospace specified devices are required,
please contact the National Semiconductor Sales Office/
Distributors for availability and specifications.
Power Dissipation Internally Limited
Input–Output Voltage Differential 40V
Operating Junction
Temperature Range −25˚C to +125˚C
Storage Temperature −55˚C to +150˚C
Lead Temperature
(Soldering, 10 sec.) 300˚C
Plastic Package (Soldering 4 sec.) 260˚C
ESD rating to be determined.
Electrical Characteristics (Note 2)
Parameter Conditions Min Typ Max Units
Line Regulation T
A
=
25˚C, 3V ≤ |V
IN−VOUT
| ≤ 40V, 0.01 0.04
%
/V
(Note 3)
Load Regulation T
A
=
25˚C, 5 mA ≤ I
OUT
≤ I
MAX
, (Note 3) 0.1 0.5
%
Thermal Regulation T
A
=
25˚C, 10 ms Pulse 0.04 0.2
%
/W
Adjustment Pin Current 50 100 µA
Adjustment Pin Current Change 5 mA ≤ I
L
≤ 100 mA 0.2 5 µA
3V ≤ |V
IN−VOUT
| ≤ 40V
Reference Voltage 3V ≤ |V
IN−VOUT
| ≤ 40V, (Note 4) 1.20 1.25 1.30 V
10 mA ≤ I
OUT
≤ 100 mA, P ≤ 625 mW
Line Regulation 3V ≤ |V
IN−VOUT
| ≤ 40V, (Note 3) 0.02 0.07
%
/V
Load Regulation 5 mA ≤ I
OUT
≤ 100 mA, (Note 3) 0.3 1.5
%
Temperature Stability T
MIN
≤ Tj≤ T
MAX
0.65
%
Minimum Load Current |V
IN−VOUT
| ≤ 40V 3.5 5 mA
3V ≤ |V
IN−VOUT
| ≤ 15V 2.2 3.5 mA
Current Limit 3V ≤ |V
IN−VOUT
| ≤ 13V 100 200 320 mA
|V
IN−VOUT
|=40V 25 50 120 mA
Rms Output Noise,%of V
OUT
T
A
=
25˚C, 10 Hz ≤ f ≤ 10 kHz 0.003
%
Ripple Rejection Ratio V
OUT
=
−10V, F=120 Hz, C
ADJ
=
065dB
C
ADJ
=
10 µF 66 80 dB
Long-Term Stability T
A
=
125˚C 0.3 1
%
Note 1: “Absolute Maximum Ratings” indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
functional, but do not guarantee specific performance limits.
Note 2: Unless otherwise specified, these specifications apply −25˚C ≤ T
j
≤ + 125˚C for the LM337L; |VIN−V
OUT
|=5V and I
OUT
=
40 mA. Although power dissi-
pation is internally limited, these specifications are applicable for power dissipations up to 625 mW. I
MAX
is 100 mA.
Note 3: Regulation is measured at constant junction temperature, using pulse testing with a low duty cycle. Changes in output voltage due to heating effects are covered under the specification for thermal regulation.
Note 4: Thermal resistance of the TO-92 package is 180˚C/W junction to ambient with 0.4" leads from a PC board and 160˚C/W junction to ambient with 0.125" lead
length to PC board. The M package θ
JA
is 180˚C/W in still air.
www.national.com 2
Loading...