Noztek Winder 2.0 User Manual

1

Warranty / Safety 3

Diagram / Introduction 4

Quick-start Guide 5

Maintenance / Troubleshooting 7

Contact Noztek 8

2

WARRANTY

• Equipment manufactured by Noztek carries the standard machine tool guarantee of freedom from defects in workmanship and material for one year from date of shipment.

• TO INSURE THAT YOUR WARRANTY IS HELD IN EFFECT, PROPER OPERATION PROCEDURES MUST BE OBSERVED.

• NOTE: READ THE SAFETY PRECAUTIONS BEFORE OPERATING THIS MACHINE.

SAFETY

1. Know your equipment

2. Carefully read the instruction manual before operating.

3. Learn the proper uses and limitations of the equipment.

• DO NOT operate or use this equipment for any purpose other than its intended use.

• DO NOT modify this equipment.

• DO NOT perform adjustments or maintenance while system is operating

• DO NOT clean the equipment with flammable solvents.

• DO NOT wash down the equipment with water. This could cause an electrical hazard.

3

Spool

Guide

Sensor

Tension Wheel

Touch Screen

INTRODUCTION

The Noztek Filament Winder reliably winds your filament onto the spool, with all the customization you need when testing different materials and tolerances. Using a laser to monitor and control the filament position optimally lined up between the Tolerance Puller and your 3D Printer

Please note: This machine cannot be used to wind transparent filament as the laser sensor will not detect the filament correctly.

4

QUICK START GUIDE

Please read through this quick start guide before attempting to use this machinery

1. Power on using switch at the rear of the machine, the home screen will appear (image 2)

2. Press Set Guide Limits. Here you can adjust the Guide Position. Use slider or +/buttons to set in alignment with your spool. You are also able to set Motor Speed and set Filament tolerance here.

3. Press Calibrate sensors and grab a small piece of filament, wave this in the sensor while the calibration performs (progress bar will appear).

4. Return to home screen using back arrow in top left corner

5. Insert end of Filament through tension wheel, sensor and guide, and into the hole on wheel as photographed on the next page

6. Your settings will now be ready when Auto Mode is launched (image 1), these will remain the default settings until you reset them.'Testing' will prompt you create settings according to the filament you are using. This will likely not be necessary unless you're using an unusual type of filament.

Your settings will now be ready when Auto Mode is launched (image 1), these will remain the default settings until you reset them.

Image 1 Image 2

5

6

MAINTENTANCE

Regular cleaning of your machine during the disassembly process lengthens machine life, helps reduce waste and helps maintain tighter tolerances and quality for your final product.

MAXIMIZING ON YOUR EXTRUDING QUALITY & EXPERIENCE

Professional results require professional equipment. At Noztek we have deeply investigated industrial models and explored the possibilities of matching the results found. Our range of professional grade machinery is designed to work together in harmony to provide optimum quality from pellet to print.

Set up this system in along with a Noztek Filament Winder for best results. A Noztek Resin and Filament Dehydrator may also be used to further enhance the quality of the eventual print by removing all residual moisture from the filament.

To see our full range of extrusion systems, head to noztek.com/products

7

CONTACT NOZTEK

Please see our FAQ help section on our website at www.noztek.com for further trou- bleshooting. If the answer to your query is not found here, please contact the Noztek expert team directly.

Noztek Ltd Unit C3 Dolphin Industrial Estate Evershed Way, Shoreham by Sea West Sussex BN43 6QB ENGLAND

44 (0) 203 384 6208

info@noztek.com www.noztek.com

8

Noztek Winder 2.0 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual