SMS80R
INSTRUCTION MANUAL
Manual version 1.0
This user manual will help you assemble and operate this product safely and quickly,
so please spend a couple of minutes to read through the enclosed information.
Due to continuous product development, please check for the latest version of this product manual at:
www.novopro.co.uk
Designed and engineered in the UK and manufactured in China for Novopro Ltd.
Novopro Ltd is a trade-only supplier and only supply wholesale to trade resellers.
At the end of the products working life, please take it to a recycling plant for environmentally friendly disposal.
Due to continuous product development, specifications and appearance are subject to change. E&OE. © Copyright Novopro Ltd.
2
Thank you for purchasing this Novopro product.
Unpacking and safety Please unpack your new product carefully. Your product should reach you in perfect condition. Please check that
no damage has occurred during transit. If any damage is found or there are any missing pieces from the packing list, please contact the
retailer you purchased it from immediately. Do not attempt to assemble it unless you have everything listed below.
Packing list
A: 1 x allen (hex) key
B: 4 x hex bolts (these will be supplied screwed into each end of the stand poles for shipping)
C: 4 x washers
D: 2 x cable management clips
E: 2 x stand bases
F: 2 x stand poles with auto-lock ratchet system
G: 2 x top plates
H: 4 x EVA foam pads for top plate
I: 1 x instruction manual (this document)
The Novopro SMS80R monitor stand has been designed for ease of use as well as safety. The stand has an integral auto-lock ratchet
system which allows you to adjust the height and lock the pole to that height without the usual slipping of standard monitor stands.
3
Assembly
4
Height adjustment
Unlock the pole mechanism by loosening the thumb screw by rotating it anti-clockwise. Now press the auto-lock ratchet button
(see diagram below). At the same time, pull the upper pole upwards.
When the pole has reached your desired height, release (let-go-of) the auto-lock ratchet button and tighten the thumb screw by
rotating it clockwise. This will lock the pole at the height you need.
To reduce the overall height of the pole, begin by removing the speaker and then loosening the thumb screw by rotating it
anticlockwise. Next press the auto-lock ratchet button whilst at the same time supporting the weight of the top pole. The upper pole
will now lower down by gravity. When the pole reaches your desired height, release (let-go-of) the auto-lock ratchet button and tighten
the thumb screw by rotating it clockwise. This will lock the pole into place at your required height.
The stand will now be sufficiently stable but due diligence and appropriate safety measures must be implemented and adhered to within
public areas. It is the user’s responsibility to use the product in a safe manner and within current Health and Safety Guidelines.
Specifications
Height: 680mm – 1100mm / 26.7 – 43.3 inches
Maximum load: 40Kg / 88lb
Material: Ø 35mm / 1.37 inches aluminium pole and steel outer pole
Surface and colour: black powder coated
Weight: 3.2Kg / 7lb
Due to continuous product development, specifications and appearance are subject to change. E&OE. © Copyright Novopro Ltd.
Loading...