Novolink NLBLLIGHTSV01 User Manual

LED String Lights with Wireless Smart Control

Thank you for purchasing our Novolink Outdoor String Lights!

To insure proper installation and prior to use, please read these

instructions and all warnings thoroughly.

Need Add-on Extensions or

additional String Lights?

www.shopNovolink.com

Installation:

1. Before use and mounting, place the

light set on a clean, at surface and

check for any damage to the LED lights,
connections, interconnection coupler,
supply cord or adapter plug.

2. Never use sharp or pointed objects to
install / mount a string light set or chain.

3. Fixing with metal or braided wire,
or similar devices is not advisable.
Metal or braided wire can damage the
insulation layers of the light set.

4. Suitable installation devices include
cable conduits or soft cable ties. When
using cable ties, ensure they are not
excessively tightened to the string to
avoid damage to the insulation layers of
the light set.

5. The supply cord and rope body must
not be subject to push, pull or torsion
forces.

6. Ensure a correct and secure connection
between the supply cord and the
light chain coupler, as well as for all
interconnected light chains. The end
cap of the last light set must always be
in place and tightened.

7. When connecting additional lights
to a set, make sure the Controller/
Transformer portion of the lights is not
plugged-in and powered.

8. Ensure that the light chain, supply
cord or interconnection couplers are
not located in or near running water or
drains (e.g. snow, streams, rain gutters).

9. If the light set does not work, have it

checked by a certied technician.

Instructions for Use

Once the light set is properly mounted,
and attached to the power adapter, plug
the adapter into the appropriate electrical
outlet.

The lights should turn ON, and may already
be set to one of 8 settings, including 6

ashing settings, one steady setting, and

one “All-in-One” setting that cycles through

all 6 ashing patterns.

Press the button on the control box to

select a dierent light mode. These light

modes include: “All-in-One” Combination
> Glimmer > Twinkle > Sparkle > Flash >
Starry > Pulse > Steady > OFF.

The built-in timer will keep the lights on
for 6 hours after a light mode is selected.
Afterwards, it will turn-OFF automatically.
the light will turn-ON again after 18 hours
unless the OFF mode is selected.

Adding Extensions:

Up to 2 extensions can be attached in a
light string. Extensions for the string lights
can be purchased at www.shopNovolink.com.

Using the Novolink D-Lights App

(For string lights featuring Wireless Smart Control)

Scan the QR Code or go to
www.novolinkinc.com to download
the iOS or Android D-Lights App.

Once you’ve downloaded the app,
you’ll receive instruction on how to use
the string light with your smartphone
or tablet.

WARNING:

This s trin g ligh t set is not a toy - ple ase
keep it o ut of re ach of c hild ren. The light

set sho uld not be p lugge d in while s till in
the packaging. The bulb s and LED stems
are fra gile. For indoor a nd outdoor use.
Do not at tempt to ha rd-wi re the lig ht set to
anothe r light s et. The e lectr ic cord c annot be
replaced.

Caution: If the ligh t(s) are da maged o r do
not work p roper ly, the whol e unit should be
repla ced if un der warranty, or disposed of
in acco rdanc e with loc al, sta te and fed eral
regulations.

WARNING -

RISK OF ELECTRIC SHOCK.

IF BULBS ARE BROKEN OR MISSING,

1. When connecting an Add-On Set to a

2. The total connected sets may not exceed

3. Ensure that the supply cord and inner wiring

4. Never hang or mount any object to the

5. Always disconnect the adapter from the

DO NOT USE.

Controller/Transformer Set, the screw cap

must be rmly tightened.

the maximum allowed number of 2 Add-On
Sets to a Controller/Transformer Set. If this
limit is exceeded, it may result in a risk of
electric shock.

are not subject to mechanical load/stress.

lighting chain.

electrical outlet when the light set is not in
use, or when the area where it is in use is
unattended for long periods of time.

6. For outdoor use, ensure the electrical outlet
or any extension cord is in compliance with
the protection class IP44 (splash water proof).
If there is any doubt, consult a professional
electrician.

7. Each section of a connected light set must
be mounted individually.

8. Dispose of an entire light set if any portion of
it is mechanically or electrically damaged.

Product Warranty &
Support Information:

This product comes with a limited warranty of
3 month from the date of purchase. (Proof of
the date of purchase must be provided if the
product is returned.) If the product is found
to be defective in material or workmanship,
Novolink will replace the defective part(s).
If any of the product parts are found to be
missing, please contact Novolink within ten
(10) days of purchase.

NOVOLINK, INC., 14860 Central Avenue
Chino, CA. 90710

Email: [e-mail]

Call: 1-800-933-7188

FCC WARNING

NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment

o and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and

receiver.

- Connect the equipment into an outlet on a circuit

dierent from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV

technician for help.

Changes or modications not expressly approved by

the party responsible for compliance could void the
user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,

including interference that may cause undesired
operation.